Peavey PV® 15 PM
SPECIFICATIONS
Enclosure: Peavey PV® 15 PM
Frequency Range
Frequency Response (+/- 3dB, half space): 69 Hz to 17 kHz
Sensitivity (1w/1m): 98 dB
Maximum SPL: 119 dB
Transducer Compliment: Sheffield® Pro 1500+™ 15” premium woofer, 14T™ 1.4” titanium diaphragm dynamic compression driver on 75° X 75° coverage Quadratic Throat Waveguide™ horn.
Nominal Coverage Pattern: 75° by 75°
Input Connections: Combo female XLR and 1/4" TRS phone jack. It is switchable between
Enclosure Materials & Finish:
Mounting or Suspension: Steel 1 3/8”
Dimensions: (H x W x D)
Front: 16.13 in. x 25.38 in. x 18.00 in.
410 mm x 645 mm x 457 mm
Weight: 47 Lbs. (21.4 kg)
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Power Amp Ratings:
Woofer - 150 Watts @ less than 0.1% distortion
Tweeter - 50 Watts @ less than 0.1% distortion.
Electronic Input Impedance (Nominal): Primary balanced
input: 20 k Ohms line level sensitivity selected, 2.4 k Ohms mic level sensitivity selected, 10 k Ohms unbalanced 1/4".
Mic Switch Sensitivity Increase: 30 dB
Infrasonic Filter Protection: 36 dB/octave
Nominal Amplifier Frequency Response: +0,
Woofer Servo Distortion Reduction: 10 dB
Equal Loudness Compensation Dynamic Range: 35 dB, frequency response of this stage is fully flat 10 dB below full amplifier power.
Hum and Noise: Greater than 90 dB below rated power
DDT Dynamic Range: Greater than 14 dB
THD and IM: Typically less than 0.1 %
Damping Factor: Greater than 100 @ 1000 Hz, 8 Ohms
Power Requirements of Peavey PV® 15 PM System (domestic): Nominal 110 Watts, 120 VAC, 60 Hz
Features and specifications subject to change without notice.
Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305
(601)
21