Step by Step Installation

Rear Seat	Rear/Trunk
	of Car

Figure 2

Figura 2

Abbildung 2

Step 1: Determine where the speaker will be mounted.. Make sure there is a flat area large enough for the speaker to fit properly.. An uneven mounting surface can damage the driver..

Step 2: Check to make sure the space you have chosen for the speaker will not interfere with the operation of the vehicle..

Step 3: Using a template, mark the speaker hole with a pen..

Step 4: Cut the hole for the speaker.. When using factory locations, this step can be passed.. A hole can be cut either with a pair of metal tin snips or a hole saw corresponding to the size of the speaker listed below.. • 4 3/4" (120mm) hole saw (5 1/4")

• 5 1/2" (140mm) hole saw (6 1/2")

Step 5: Run the speaker wire to the speakers.. Make sure to keep wires away from sharp metal or other edges.. When passing through metal ,use a protective grommet..

Step 6: Using the template, mark the mounting holes with a pen..

Step 7: Pre-drill mounting holes using a 1/8" drill bit..

Step 8: Pull the wire through the speaker opening and connect to the speaker..

Step 9: Mount the speaker and grill in the hole using the same screws.. Insert the screws through the grill and the mounting holes in the basket..

WARNING: Window mechanisms and electrical wires may be hidden from sight. CHECK FOR CLEARING BEFORE YOU DRILL!

4	© 2009 directed electronics—all rights reserved