Timers—Continued
STANDBY/ON CLOCK
CALL
2 3
1TIMER
5 | 6 |
4 |
|
8 | 9 |
7 |
|
CLEAR | |
10/0 | ENTER |
DISPLAY | MODE |
TIMER
ENTER
Using the Sleep Timer
With the sleep timer you can set the
1 Press the [SLEEP] button repeatedly to select the required sleep time.
SLEEP | SLEEP | REPEAT |
| MUTING | INPUT |
Turning Timers Off
With the [SLEEP] button you can set the sleep time from 90 to 10 minutes in 10 minute increments.
The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about five seconds, then the previous display reappears.
Sleep indicator
You can turn timers on or off as necessary. This can be use- ful when, for example, you’re on holiday and you don’t want to be woken up by the timer that you normally use as an
1 Press the [TIMER] button repeatedly to select the timer that you want to turn off.
2 Use the Up/Down [
]/[ ] buttons to select “Timer OFF.”
The timer is turned off, and the previous display reap- pears after two seconds.
To turn a timer back on again, repeat this procedure and use the Up/Down [
]/[ ] buttons to select “Timer ON.”
To cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.
Checking Timer Settings
You can check a timer’s settings as follows.
1 Press the [TIMER] button repeatedly to select the timer that you want to check.
2 Press the [ENTER] button repeatedly to cycle through the timer’s settings.
Note:
You can edit the selected timer’s settings as you check them. To do this, use the Up/Down [
]/[ ] buttons to edit the cur- rently displayed setting, and then press [ENTER] to move on to the next setting.
34