Onkyo M-5000R instruction manual Bi-amping Connection

Page 18

Bi-amping Connection

Preamplifier P-3000R

Power Amplifier M-5000R

Power Amplifier

M-5000R

Tweeter (high)

Woofer (low)

Right speakerLeft speaker

 

This is an example of the bi-amping connection using the preamplifier P-3000R.

 

 

 

 

 

Note

 

 

 

 

 

 

• Set the INPUT SELECT switch to RCA side.

 

 

Important:

 

 

• When making the bi-amping connections, be sure to remove the jumper bars that link the speakers’ tweeter (high) and woofer (low) jacks.

En

 

Bi-amping can be used only with speakers that support bi-amping. Refer to your speaker manual.

18

Image 18
Contents 5000R Read these instructions Clean only with dry clothDo not block any ventilation openings. Install Keep these instructionsPreventing Hearing Loss Caution PrecautionsPower Batteries and Heat Exposure WarningFor British models Power cord Amplifier PrecautionsInstallation location and space VentilationOther PowerCare Lightning stormsFeatures Technology Wrat Advanced Wide Range Amplifier TechnologyBlock Diagram Supplied Accessories Power cordMono mini-plug cable Contents Meter Range LEDs Getting to Know the Power AmplifierFront Panel ON/STANDBY buttonRear Panel Installing the Power Amplifier About XLR Input ConnectionsCable and Jacks Plugging the XLR cableConnecting the Power Cord Plug the power cord into an AC wall outletConnecting a Preamplifier Preamplifier P-3000R Power Amplifier M-5000RStereo Connection Bi-amping Connection AV Controller PR-SC5508 Power Amplifier M-5000R Bridge ConnectionPress ON/STANDBY to set the power amplifier to Standby Turning On the Power AmplifierTurning Off the Power Amplifier Basic Operations` on Switching the Power Meter Range Setting Auto Standby ASbSet ON/OFF by switching the Auto Standby switch ` OFFTroubleshooting AudioExternal Components Amplifier Section Specifications5000R General Section4 0 0 5 4 5 a