Onkyo instruction manual Bridge Connection, AV Controller PR-SC5508 Power Amplifier M-5000R

Page 19

Bridge Connection

AV Controller PR-SC5508

Power Amplifier M-5000R

Right Speaker

Left Speaker

This is an example of the bridge connection with the AV controller PR-SC5508.

Note

•When using the XLR inputs, do not connect anything to the RCA inputs. It may damage the power amplifier.

•Make sure that the XLR cable is not split. The split XLR cable may be the cause of noise.

•The power amplifier uses the European type XLR jack (pin 2 hot). If the AV controller/preamplifier with the USA type jack (pin 3 hot) is connected, the phase will be reversed. In this case, reverse the polarity of the speaker connection.

•Set the INPUT SELECT switch to XLR side.

Image 19

Contents 5000R Keep these instructions Clean only with dry clothDo not block any ventilation openings. Install Read these instructionsBatteries and Heat Exposure Warning PrecautionsPower Preventing Hearing Loss CautionFor British models Ventilation Amplifier PrecautionsInstallation location and space Power cordLightning storms PowerCare OtherFeatures Wrat Advanced Wide Range Amplifier Technology TechnologyBlock Diagram Power cord Supplied AccessoriesMono mini-plug cable Contents ON/STANDBY button Getting to Know the Power AmplifierFront Panel Meter Range LEDsRear Panel Installing the Power Amplifier Plugging the XLR cable ConnectionsCable and Jacks About XLR Input Plug the power cord into an AC wall outlet Connecting the Power CordPreamplifier P-3000R Power Amplifier M-5000R Connecting a PreamplifierStereo Connection Bi-amping Connection Bridge Connection AV Controller PR-SC5508 Power Amplifier M-5000RBasic Operations Turning On the Power AmplifierTurning Off the Power Amplifier Press ON/STANDBY to set the power amplifier to Standby` OFF Switching the Power Meter Range Setting Auto Standby ASbSet ON/OFF by switching the Auto Standby switch ` onAudio TroubleshootingExternal Components General Section Specifications5000R Amplifier Section4 0 0 5 4 5 a