Installation
2
Hex Nut (M5) | Screw |
Caution
Do not block the unit’s heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.
Heat sink
*2
Metal
Mounting
Strap
*1
Ground Lead
Bolt Stud
This unit
Detachable
Front Panel
Caution
When you install this unit in your car, do not remove the detachable front panel.
If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.
•The main unit must be mounted within 35 degrees of the horizontal plane, back to front.
Less than 35°
1 | Mounting Sleeve |
| (Included) |
Dashboard
Pressure Plates*
This unit
*If the installed mounting sleeve is loose in the main unit, the pressure plates may be widened slightly to remedy the problem.
Remove mounting sleeve from the main unit (see “Removal” on page 44).
Chassis
Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle’s chassis.
•For the screw marked “*2”, use an appropriate screw for the chosen mounting location.
| Connect each input lead coming from an amplifier or |
| equalizer to the corresponding output lead coming |
| from the left rear of the |
| leads of the |
| described in the CONNECTIONS section. |
3 | Slide the |
| clicks. This ensures that the unit is properly locked |
and will not accidentally come out from the dashboard. Install the detachable front panel.
Removal
1.Remove the detachable front panel.
2.Insert the bracket keys into the unit, along the guides on either side. The unit can now be removed from the mounting sleeve.
This unit
Bracket keys (Included)
3. Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
|
|
|
|
|
|
| Front Frame | |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
This unit |
|
|
|
| Screws (M5 × 8) | |||||||||||
|
|
|
| (Included) | ||||||||||||
|
|
|
|
|
|
|
|
| ||||||||
Ground Lead
*3 
Mounting Bracket
•Secure the ground lead of the unit to a clean metal spot using a screw (*3) already attached to the vehicle’s chassis.