Getting Started
Double Action encoder
| SOURCE | /ENTER | VIEW |
|
|
| (FUNCTION/SETUP) |
Accessory List |
|
| |
• | Digital Media receiver | 1 | |
• | Power cable | 1 | |
• | Mounting sleeve | 1 | |
• | Carrying case | 1 | |
• | Front frame | 1 | |
• | Bracket key | 2 | |
• | Screw (M5x8) | 4 | |
• | USB cable | 1 | |
• iPod Dock interface cable | 1 | ||
• | Owner’s Manual | 1 set | |
Turning Power On and Off
Press 
SOURCE to turn on the unit.
•The unit can be turned on by pressing any other button except
(Release), Double Action encoder and 
VIEW. The unit is also automatically turned on if an iPod/iPhone or USB memory is connected.
Press and hold 
SOURCE for at least 2 seconds to turn off the unit.
Detaching and Attaching the Front Panel
Detaching
1 Turn off the unit power.
2 Press 
(Release) at the lower left side until the front panel pops out.
3 Grasp the left side of the front panel and pull it out.
•The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel.) This is not a malfunction.
•To protect the front panel, place it in the supplied carrying case.
Attaching
1 Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.
2 Push the left side of the front panel until it locks firmly into the main unit.
•Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
•Attach the front panel carefully. Hold the panel by its sides to avoid pushing any buttons by mistake.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after changing the car battery, etc.
1 Turn off the unit power.
2 Press 
(Release) to remove the front panel.
3 Press RESET with a ballpoint pen or similar pointed object.
Adjusting Volume
Rotate the Double Action encoder until the desired sound is obtained.
Setting the Time and Calendar
1 Press and hold 
(FUNCTION/SETUP) for at least 2 seconds to activate the SETUP selection mode.
2 Rotate the Double Action encoder to select “General”, and then press 
/ENTER.
BLUETOOTH 
General 
Display 
iPod 
XM* 
SIRIUS* 
HD Radio* 
Audio
* Only when HD Radio Tuner/SAT Radio receiver is connected.
3 Rotate the Double Action encoder to select Clock Adjust, and then press /ENTER.
The calendar setting mode is activated.
When the year is set, proceed step 5.