|
| Troubleshooting chart | |
|
|
|
|
Advanced Features
Headphones
Before plugging in or unplugging the headphones, reduce the volume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms.
Plugging in the headphones disconnects the speakers automatically. Adjust the volume using the VOLUME control.
Many potential problems can be resolved by the owner without call- ing a service technician.
If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre.
General
Symptom | Possible cause |
|
|
The clock is not set to the | Did a power failure occur? Reset |
correct time. | the clock. |
|
|
When a button is pressed, | Set the unit to the power stand- |
the unit does not respond. | by mode and then turn it back on. |
| If the unit still malfunctions, reset |
| it. |
|
|
No sound is heard. | Is the volume level set to "0"? |
| Are the headphones connected? |
| Are the speaker wires discon- |
| nected? |
|
|
CD player
Symptom | Possible cause |
|
|
Playback does not start. | Is the disc loaded upside down? |
Playback stops in the | Does the disc satisfy the |
middle or is not performed | standards? |
properly. | Is the disc distorted or |
| |
| scratched? |
|
|
Playback sounds are | Is the unit located near excessive |
skipped, or stopped in the | vibrations? |
middle of a track. | Is the disc very dirty? |
| |
| Has condensation formed inside |
| the unit? |
|
|
38