~
Removing the Radio
To remove the radio after installation, remove the trim ring by pulling outward on one side and then the other. Insert the removal keys straight back, with the notches facing up, until they lock. With the removal keys engaged, pull the radio straight out. If removal keys are inserted at an angle, they will not lock properly to release the unit.
HD5212
y~~.:.~
o
REMOVAL KEYS
Connecting the Satellite Radio Receiver (optional)
Before you can listen to satellite radio, you must install the satellite receiver and antenna (purchased separately). The satellite radio receiver is the central data receiving equipment required to process the satellite signals from the external antenna. It is typically installed in the dash, under the seat, or in the trunk or rear of the vehicle. Do not mount receiver near a heater vent or where it can be exposed to extreme temperatures. In addition, when running the wire for the external antenna do not kink or pinch the antenna cable. A sharp 90 degree bend or slight "nick" to the outer cable sheath will cause signal degradation. The wiring diagram will help you identify the proper connections.
Technical Assistance
If you require assistance, contact Technical Support at
6