Display D, Front Panel Release, Reset Button

CD1211

Display (D)

When the unit is off, the LCD displays the time of day. When the unit is on, the LCD automatically shows the tuner or CD display, depending on which mode of operation is currently activated.

Display Clock

During tuner or CD operation, press D (9) to display the time of day. After five seconds, the display reverts to tuner or CD display.

Set Clock

1.	To set the clock, turn the radio on in tuner
	mode (or any other mode).
2.	Press D. The time appears on the display.
3.	Press and hold D until the time display
	begins flashing.

Front Panel Release

The front panel release button (10) releases the mechanism that holds the front panel to the chassis.

Detaching the Front Panel

To detach the front panel, first press the front panel release button (10) to release the left side of the panel. Next, grasp the released side and pull it off the chassis. After removing the front panel, store it in the supplied carrying case to protect it from dirt and damage.

REMOVE FRONT PANEL

that it is correctly engaged, then lightly press the left side of the panel until the mechanism locks it into place.

Reset Button

The reset button (11) is located on the front of the chassis and can only be accessed with the front panel removed. The reset circuitry protects the microprocessor circuitry. Since resetting the unit will erase the time and preset memories, it should only be activated upon initial installation after all wiring is complete, or if there is a malfunction of any of the switches on the unit. In these circumstances, pressing the reset button will clear the system and return the unit to normal operation.

4.	While the display is flashing, press the Up
	Tuning button (14) to adjust hours and the
	“A” (AM) or “P” (PM) indication. Press the
	Down Tuning button (13) to adjust
	minutes.
5.	After five seconds, the time will set and the
	display will return to tuner or CD display.

MONO

CD1211 CD	RECEIVER

SCAN

/ AUX IN

TUNE

RESET

Auxiliary Input

Use the Aux In connector (19) to connect a portable media device for playback through the vehicle sound system.

Re-attaching the Front Panel

To re-attach the front panel, make sure the electrical terminals on the back of the panel are free of dust and dirt, as debris could cause intermittent operation or other malfunctions. Position the right side of the panel in place so

Theft Deterrent LED

A light-emitting diode (LED) (12) is located on the chassis behind the front panel and will flash when the panel is removed. The flashing light serves as a visual warning to the would-be thief that the unit has been disabled by removal of the front panel.