Lanzar Car Audio VBD1800 owner manual DIN REAR-MOUNT Method B, Removing the unit

INSTALLATION

Removing the unit

1

2

3

1.Frame

2.Insert fingers into the groove in the right side of the frame and pull out to remove the frame. (You can also remove the frame from the left side.)

3.Lever

After removing the frame and when the front panel is hidden, then insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click.

Pulling the levers makes it possible to remove the unit from the dashboard.

DIN REAR-MOUNT (Method B)

31

2

4

6 5

Tab

1.Factory-installed radio bracket

2.Car radio mounting bracket

3.Screw

4.After aligning the car radio mounting bracket with the factory-installed radio bracket, tighten the screws (5 x 5mm) at 2 places on each side.

5.When fixed factory-installed radio bracket with the screws, use a standard-tipped screwdriver to pry the tabs of the car radio mounting bracket to make them fit into the holes in the factory-installed radio bracket.

6.Movable panel frame

4