Lanzar Car Audio MAXP 2760, MAXP 4260, MAXP 2960 user manual Amplifier Featuer Descriptions

Page 3

AMPLIFIER FEATUER DESCRIPTIONS

~Z760fNU'XPZ960 Z CHANNELAMPUFIERS

The X..oVER slide switch selects the intermal crossover functions:

-The input signal is routed directiy to the UNE OUT RCAjacks. regardless of the X-OVERsetting simplifying daisy chaining of amplifiers.

HP: Selects the built in HIGH PASS filter. variable from 40 Hz to 2KHz.

FlAT: Bypasses all crossovers for full frequency range operation.

LP: Selects the built in LOW PASS filer. variable from 30 Hz to 150Hz. Note that the LOW PASS signal is MONO

-In the LP position. the HIGH PASS filter acts as a subsonic filter. When the LP mode is selected. a 0 to + I 0 dB. at 45 Hz. BASS EO is also switched in.

The REMOTEjack enables dash mount level control of the LOW PASS signal.

~4Z60

4 CHANNEL AMPLIFIERS

The AMPLIFIER CH I/ZCH X-OVERslide switch selects the input signal for

channel pair 1& 2:

HP: Selects the built in HIGH PASS filter. variabe from 40 Hz to 2KHz.

·FULL: Bypasses all crossovers for full frequency range operation.

·LP: Selects the built in LOW PASS filter. variabe from 30 Hz to 150Hz. Note that the LOW PASS signal is MONO.

-In the LP position. the HIGH PASS filter acts as a subsonic filter.

-When the LP mode is selected. a 0 to + I 0 dB. at 45 Hz. BASS EO is also switched in.

The AMPLIFIER CH 3/CH 4 X-OVERslide switch selects the input signal for channel pair 3&4

HP: Selects the built in HIGH PASS fiter. variable from 40 Hz to 2KHz.

·FULL: Bypasses all crossovers for full frequency range operation.

·LP: Selects the built in LOW PASS filter. variabe from 30 Hz to 150Hz. Note that the LOW PASS signal is MONO.

-In the LP position. the HIGH PASS filter acts as a subsonic filter.

-When the LP mode is selected. a 0 to + I 0 dB. at 45 Hz. BASS EO is also switched in.

-Full range signal from channels I I 2 inputs are routed to the Une OUT RCA jacks. regardless of the setting of the X-OVERswitches.

-The REMOTEjack enables dash mount level control of the LOW PASS Signal. CH3/40nly.

FEATURES

Bass Boost Circuit

Variable low Pass Crossover

Anti-Thump Turn-On

Tri-Mode Configurable

Soft Turn On/Off

RCA Une Input

Blue light Illuminated lanzar Logo

Power Protection LED Indicators

Advanced Protection Circuitry

Bass Boost Remote Control

THD: <0.05%

SIN Ratio: >95dB

Frequency Response: 10Hz-40KHz

-

Image 3
Contents USER’S Manual Introduction Table of ContentsAmplifier Featuer Descriptions ~i,!!l ~COl~6fJLrr Interconnect cable checklist Level control checklist MAXP42604 Channel Amplifier Applications HIgh Pass Setting UP Systems After Installation for Best PerformanceLanzar MAX PRO Series Amplifier Features Amplifier will not Power UP Troubleshooting