MAXP4260 4 CHANNEL AMPLIFIER APPLICATIONS
2 way active, or b ....mpllfted system with mono bass
This application shows how easily a 2 way active system can be implemented using a MAX PRO series 4 channel amplifier. Channels I and 2 will be used for highs, and channels 3 and 4 for mono bass.
Interconnect cable checklist:
Level control checklist:
Refer to the section "setting up systems after in stall ation for best performance"
Mlnmum ftnalloudspeaker Impedances: ·2 ohm per channel in stero mode
·4 ohm mono bridged.
-We need to feed the same signal to both sets of channels, so must use 2
Mono bass woofer wiring
-Connect the mono speaker positive terminal to the RIGHT +, and its negaitive terminal to LEFT
Switch setting checklist:
•1/2CH
•3/4CH
Crossover frequency control checklist: channels 1/2
·HIGH PASS: 100 Hz
•HIGH PASS (subsonic!: 20 Hz
•Low PASS: 100 Hz
Please note that these frequency points only. Refer to the
loudspeaker manufacturer specifications and the section
"setting up system after installation for best performance-
LEFT TO Cfi..\NNELS
I AND 3
STEREO
~FULLMNGE
OR HIGHS + SPEAKERS
STEREO
!OFUURANGE + OR HIGHS
SPENCERS
~MONO
f{tI OR SUB s.\SS
SPENCERS
TO M.TTEIn' + 12V
VIA FUSE
REMOTE
CH.\SSIS GROUND
2way active, or
Here we present a variation of the previous system. Since this is a 2 way system, wecan use the front outputs from a head unit to drive the highs, and the rear output to drive the bass This method allows the listener to easily adjust the relative levels of bass to highs, with the front to rear fade on the head unit. Channels 1 anf 2 will be used for highs, and channels 3 and 4 for mono bass.
interconnect cable checklist:
-Use good quality RCA leads to connect the inputs of the amplifier to the source as shown.
-Follow the instructions as per the previous system for switch and crossover settings.
FU1J.RANGE
STEREOUNE
INPUTS
STEREO rn FUll. RANGE + OR HIGHS
SPENCERS
~STEREO
~FUURANGE
OR HIGHS r1\ SPENCERS
!iJ MONO OR SUB MSS
SPENCERS
-