Lanzar Car Audio MAXP 4260, MAXP 2760, MAXP 2960 user manual ~i,!!l

MAXP2760/MAXP2960 2 CHANNEL AMPLIFIER APPLICATIONS

FULL RANGE STEREO

This ;s the most basic application for the MAX PRO

Series 2 channel amplifiers.

Q

1. Interconnect cable checklist:

Connect the UNE INPUTS to the Radio/CD with good quality RCA cables.

Z. Crossover Switch:

The X-OVER switch must be in the FlAT position.

3.Crossover frequency control checklist:

N/A for full range operation.

4.Line level:

Refer to the section "Setting up systems after installation for best performance-

S. Bass Remote:

Plug in the Bass Remote to the amplifier -REMOTE-jack.

NOTE: Minmum tinalloudspeaker impedances:

4& Z Ohms stereo mode or 4-Ohms mono mode This amplifier will not do I Ohm stereo or Zli Ohm mono operation.

I

f~:

11'11

;e:b£([J1flf1:Ecm[!D

ilSl ' :6),

foo/

"C.1

<!!I

		FUll. RANGE
		SPEAKERS
~		ro
	r
~	t	ro
~ r~
	L""",
L		TO BAITER'Y +I2V
	:.	VIA FUSE
~		REMOTE TIJRN-ON
		CHASSIS GROUND

iii

FULL RANGE MONO

This application illustrate the basic mono bridging method fat alllanzar amplifiers.

Interconnect cable checklist:

AMONO signal source is required. such as would be available from the mono sub bass output of an active crossover, whether stand alone. or built into a head unit or equalizer. Important: Do not be tempted to

connect the hot, or positive outputs. from any source

together to obtain a mono signal, as this CQuid very well damage the output stage of that source. It is necessary to feed the SAME signal to both left and right inputs via a Y-adapter RCA cable. Connect the mono speaker positive terminal to the LEFT+, and its negative terminal to RIGHT-.

Switch setting checklist:

-The AMPUFIER X-OVER switch must be in the FUU position.

Crossover frequency control setting checklist:

N/A for full range operation.

np: If you are using the mono sub bass output of an active crossover, there isnothing wrong with switching in the low pass filter in these amplifiers for a steeper low pass rolloff.

FUIl.R.\NGE

STEREO UNE INPUT

VIA. Y-I!.DAPTER ~

FROM MONO SOURC

Q		~i,<!!l
VQ
		I
		f~:
		;e:
		ilSl '
	:6),
		foo/
		~C~I
		~. <!!I

~

=-cu--=

b£([J1flf1:Ecm[!D

=-rn...=

~FUllAANGE

iii ~ MONOSPEAKER

~~t~r~	0
~ r~

LIlC:>IJ

L	TO BATTER'Y + I 2V
~ :.	VIA FUSE
	REMOTE TIJRN-ON
	CHASSIS GROUND

iii01

~

Minimum fin•• loudspeaker impedance:	-
-4 ohm mono.