OPERATION
Note:
1.Don’t rotate the monitor forcibly to avoid mechanical damage.
2.When the front panel is on the outside position (Slide item select the right dot.), you can adjust the angle of the panel. Pushing the front panel into the slot, the front panel will be drawn out after several seconds.
Note: Under the label (printed “Take out screw before turn TFT”), there is a screw on the back of the unit, before you turn the TFT monitor, please take it out.
screw
Mode Selection
1)Tap SRC icon on the touch screen, or press and hold SET/SRC button on the front panel for several seconds, SOURCE picture will appear:
Tap the different icon on the screen to select the corresponding mode among: Radio, Media,
2)Press MODE button on the remote control to select among RADIO, MEDIA,
Remote Sensor
There is a remote sensor on the front panel. You can point the remote control handset to the remote sensor on the front panel and press function keys on the remote control to control the unit. The unit is also connected to an external remote receiver (See the electrical connection diagram above), and the function is the same with the remote sensor on the front panel.
7 Inch TFT Monitor Display
When the monitor stretches out, the 7 inch TFT Monitor display can show the current state of the unit.
Volume Level Adjustment
Press VOL+/- buttons on the remote control or +/- icon on the right side of the screen to increase or decrease the volume level.
Shortly press MUT on the front panel or MUTE on the remote control or tap
the 
icon on the right side of the screen will mute the sound. Shortly
press MUT or MUTE or tap 
icon again the sound will resume.
Note: if there is no operation of the volume bar, the volume bar will disappear automatically. Tap the right place of the scree, it will appear.
Reset
Press
on the front panel to release the front panel you will see the Reset button (See THE PLAYER picture above.) It must be activated with either a ballpoint pen or thin metal object. The reset button is to be activated for the following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
-Error symbol on the display.
Setup
Press MENU button on the remote control or tap any place on the screen
main menu will appear. Then tap 
icon on the left of the screen will enter the SETUP interface like followed picture (note: Only in Media mode the “DVD SETUP” bar can be displayed):
Note:
For all the operation on the screen, you can tap the corresponding icon on the screen or use 
/ 
, 
/ 
and OK buttons on the remote control to select and confirm.
17