Lanzar Car Audio SDBT75NU owner manual Removing the unit

Page 7

INSTALLATION

Dashboard

Tabs

Screwdriver

Sleeve

6.Reconnect the wire harness and the antenna and be careful not to pinch any wires or cables.

7.Slide the unit into the sleeve until it locks into place.

8.To further secure the unit, use the supplied metal strap to secure the back of the unit in place. Use the supplied hardware (Hex Nut (M5mm) and Spring Washer) to attach one end of the strap to the mounting bolt on the back of the unit. If necessary, bend the metal strap to fit your vehicle's mounting area. Then use the supplied hardware (Tapping Screw (5x25mm) and Plain Washer) to attach the other end of metal strap to a solid metal part of the vehicle under the dashboard. This strap also helps ensure proper electrical grounding of the unit.

Note to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard.

9.Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's front panel. (see the steps of “using the detachable front panel”).

Removing the unit

1.Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal.

2.Remove the metal strap attached the back of the unit (if attached).

3.Lift the top of the outer trim ring then pull it out to remove it.

4.Insert both of the supplied keys into the slots at the middle left and right sides of the unit, then pull the unit out of the dashboard.

Spring Washer

Metal Strap

Mounting Bolt

Hex Nut

Plain Washer Tapping Screw

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents SDBT75NU USE this Product Safely FeaturesContents Region Management Information Region Management Information Safety InformationDVD Disc NotesMP3 Installation Opening InstallationInstalling the unit Removing the unit DIN REAR-MOUNT Method B Open Position PlayerFront View Closed PositionInch TFT Touch Screen Monitor Electrical Connection Remote Sensor Connector BlackLocation and Function of Keys Remote ControlANG LOAD/EJECT a Disc Preparing the Remote ControlOpen/Close the Monitor OperationBasic Operation Turning the player on/offSetup Mode SelectionVolume Level Adjustment ResetSystem AudioSmart Mode Operation DVD Setup DefaultMute and Brake Function DVD Video Menu Play Pausing Play/Step PlaySlow Motion Playback For DVD Only Skipping TrackCancle ON-SCREEN Display FunctionRepeat a Repeat A-BProgram Play Goto FunctionZoom Function Special Functions for DVD Multi-subtitle Language FunctionLanguage Setup DVD SetupThere are two method to enter the DVD Setup menu System SetupFrequently Asked Questions Audio SetupD I O O U T KEY I T S E T U P Radio Operation USB Play Operation Switching to AV modeBluetooth Mode Selection AV OperationDial the Phone Number PairingSwitch the Phone Call between the Player and Phone Trouble Shooting Radio SpecificationsDVD
Related manuals
Manual 27 pages 63.88 Kb
Top Page Image Contents