Trouble Shooting

If it appears that your DVD unit is faulty, first consult this checklist. It may be that something simple has been overlooked.

Under no circumstances should you try to repair the player yourself, as this will invalidate the warranty. Only qualified service personnel can remove the cover or service this player.

NO POWER

•Check if the on/off button on the front of the player is set to on.

•Check if AC or DC power plug of the mains unit is properly connected.

•Check if there is power at the AC or DC outlet.

NO PICTURE

•Check if the mode it set to proper state, such as DVD mode, RADIO, TV, AV and RGB mode.

•Check the video connection.

DISTORTED PICTURE

•Check the disc for fingerprints and clean with soft cloth, wiping from centre to edge.

•Sometimes a small amount of picture distortion may appear. This is not a malfunction.

THE PICTURE IS OVER DARK, OVER BRIGHT OR HAS NO COLOR

Enter the picture setup menu (refer to the Picture mode Adjustment above) to adjust the corresponding item (BRIGHT, CONTRAST, COLOR or TINT) to proper value, then you can get an optimum picture effect.

COMPLETELY DISTORTED PICTURE

•The disc format is not according to the TV-set used (PAL/NTSC).

DISC DOES NOT PLAY

•Ensure the disc label is upwards.

•Clean the disc.

•Check if the disc is defective by trying another disc.

NO SOUND

•Check audio connections.

•If using a HIFI amplifier, try another sound source.

•Check if the volume is minimum, and adjust the VOL+ to increase the volume level.

NO RETURN TO START-UP SCREEN WHEN DISC IS REMOVED

•Press POWER to turn off the unit, then press it again to turn on the unit.

•Press Reset button on the front of the DVD unit.

THE PLAYER DOES NOT RESPOND TO THE REMOTE CONTROL

•Aim the remote control directly at the sensor on the front of the player.

•Avoid all obstacles which may interfere with the signal path.

•Inspect or replace the remote control batteries.

NO AUDIO AT DIGITAL OUTPUT

•Check the digital connections

•Check the Digital Audio menu to make sure that the digital output is correctly set.

•Check if the audio format of the selected audio language matches your receiver’s capabilities.

BUTTONS DO NOT WORK

•Turn the player off and on with the power on/off button on the front of the player.

•Press Reset button on the front of the DVD unit.