Kicker SX650.1 manual Height, Width, Length Without EndKaps, Frequency Response, Input Sensitivity

Page 19

Specifications

Specifications

to

 

all

 

models

common

.

 

Height:

2.5 inches / 6.35 centimeters

Width:

10 inches / 25.4 centimeters

Length Without EndKaps:

Subtract 5 inches (12.7 cm) from chart above

Frequency Response:

20 Hz - 200 Hz, +0 / -1 dB

Input Sensitivity:

62.5 mV - 16 V

Signal-t0-Noise Ratio:

>98 dB

High Pass Crossover Freq.:

10 Hz - 60 Hz in 1 Hz steps

High Pass Crossover Slope:

0 (off) - 24 dB in 6 dB steps

Low Pass Crossover Freq.:

30 Hz - 200 Hz in 1 Hz steps

Low Pass Crossover Slope:

0 (off) - 48 dB in 6 dB steps

KickEQ Frequency:

20 Hz - 200 Hz in 1 Hz steps

KickEQ Bandwidth (Q):

.5 to 10 in .5 steps

KickEQ Boost/Cut:

+/- 18 dB per Octave

Remote Bass Level Control:

Included with each amplifier

Power & Ground Terminals:

Will accept up to 2 Gauge wire

DSP Reaction Time / Delay:

0.7 milliseconds (In other Words...Real Fast!)

Friend’s Reaction:

That Shizzle's Off The Hizzle

Stranger’s Reaction:

Dude...Sweet...

ELECTRONICS LIMITED WARRANTY

Kicker warrants this product to be free from defects in material and workman- ship under normal use for a period of 90 DAYS from date of original purchase with receipt. When purchased from an Authorized KICKER Dealer it is warranted for TWO (2) YEARS from date of original purchase with receipt. If the product is labeled “B Stock” it is warranted for 90 DAYS from date of original purchase with receipt. If labeled “B Stock” and purchased from an Authorized KICKER Dealer, it is warranted for ONE (1) YEAR from date of purchase with receipt. In all cases you must have the original receipt! Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction during the warranty period, Kicker will replace or repair (at its discretion) the defective mer- chandise with equivalent merchandise at no charge. Warranty replacements on “B-Stock” merchandise may have cosmetic scratches and blemishes. Discontinued products may be replaced with more current equivalent products.

This warranty is valid only for the original purchaser and is not extended to owners of the product subsequent to the original purchaser. Any applicable implied warranties are limited in duration to a period of the express warranty as provided herein beginning with the date of the original purchase at retail, and no warranties, whether express or implied, shall apply to this product thereafter. Some states do not allow limitations on implied warranties, therefore these exclusions may not apply to you.

This warranty gives you specific legal rights; however you may have other rights that vary from state to state.

WHAT TO DO IF YOU NEED WARRANTY OR SERVICE

Defective merchandise must be returned to your local Authorized Stillwater Designs (Kicker) Dealer for warranty. Assistance in locating an Authorized Dealer can be obtained by writing or calling Stillwater Designs direct. You can confirm that a dealer is authorized by asking to see a current authorized dealer window decal.

If it becomes necessary for you to return defective merchandise, call the Kicker Customer Service Department at (405)624-8510 for a Return Authorization (RMA) number. Package all defective items in the original container or in a pack- age that will prevent shipping damage, and return to

Stillwater Designs, 5021 North Perkins Road, Stillwater, OK 74075

The RMA number must be clearly marked on the outside of the package. Return only defective components. Return of entire cabinets, system packs, pairs, etc. increases your return freight charges. Non-defective items received will be returned freight collect.

Include a dated proof-of-purchasestating the Customer name, Dealer name, product purchased and date of purchase. Warranty expiration on items without proof-of-purchase will be determined from type of sale and the manu- facturing date code. Freight must be prepaid; items received freight collect will be refused.

Failure to follow these steps may void your warranty. Any questions can be directed to the Kicker Customer Service Department at (405)624-8510.

WHAT IS NOT COVERED?

This warranty is valid only if the product is used for the purpose for which it was designed.

It does not cover:

Damage due to improper installation.

Subsequent damage to other components.

Damage caused by exposure to moisture, excessive heat, chemical cleaners, and/or UV radiation.

Damage through negligence, misuse, accident or abuse. Repeated returns for the same damage may be considered abuse.

Any cost or expense related to the removal or reinstallation of product.

Speakers damaged due to amplifier clipping or distortion.

Items previously repaired or modified by any unauthorized repair facility.

Return shipping on non-defective items.

Products with tampered or missing barcode labels.

Products returned without a Return Authorization (RMA) number.

Freight Damage.

The cost of shipping product to Kicker.

Service performed by anyone other than Kicker.

Speaker with any foreign caulk used for gasket material.

HOW LONG WILL IT TAKE?

Kicker strives to maintain a goal of 24-hour service for all returns. Delays may be incurred if lack of replacement inventory or parts is encountered.

INTERNATIONAL WARRANTY

Contact your International Kicker dealer or distributor concerning specific procedures for your country’s warranty policies.

P.O. Box 459 • Stillwater, Oklahoma 74076 • U.S.A. • 405 624-8510

KICKER drivers are capable of producing sound levels that can permanently damage your hearing! Turning

WARNING: up a system to a level that has audible distortion is more damaging to your ears than listening to an undistorted system at the same volume level. The threshold of pain is always an indicator that the sound level is too loud and may permanently damage your hearing.

Please use common sense when controlling volume!

Warranty

36

SX .1 Series Amplifiers

SX .1 Series Amplifiers

April 2003 37

Image 19
Contents Page SX650.1 / SX1250.1 FeaturesVFD Display VFD DisplayM1 M2 M3 M4 End Panel Views InstallationMounting Single Speaker or Voice Coil WiringInstallation Multiple Speakers or Voice Coils Parallel WiredAmplifier Strapping Multiple Speakers or Voice Coils Series WiredAmplifier Strapping with Remote Bass Control Using the Signal Output Jacks PastNavigation Using the Remote Bass Level Control & BlastMenu System Lo-Pass Hi-Pass Phase Mute Kompressor SecuritySystem GainESC key to return to the Sick ESC Noise OFfC...1, 2, 3...etc Sick BAYESC Home ENT A, B, C...1, 2, 3...etc Memory-1 Memory-2 Memory-31V, 2V, 4V, 8V LOW Medium HighBoost/cut Select Skip Reset or do ResetEQ frequency, bandwidth Menu Press the ENT key to enter LO-PASS adjustment menuATTACK, and OFF Kompressor adjustment menuDegree and 180 degree Mute OFFTimes Then press the ENT key to accept your settingUnlock Amplifier Unlock AmplifierMemory Presets PhaseLO-PASS HI-PASS €Green LED off, no output Troubleshooting€Other Symptoms HelpPerformance Model SX650.1 SX1250.1 RMS PowerDynamic Power KompressorHeight Signal-t0-Noise RatioPower & Ground Terminals DSP Reaction Time / DelayPizza Delivery Chic’s Numbers Hook Ups

SX650.1, SX1250.1 specifications

Kicker is known for its dedication to delivering top-tier audio performance, and the Kicker SX1250.1 and SX650.1 amplifiers stand out in the realm of car audio. Packed with robust features and innovative technologies, these amplifiers cater to both novice and expert audio enthusiasts.

Starting with the Kicker SX1250.1, this powerhouse monoblock amplifier is specifically designed to deliver a staggering 1,250 watts RMS at 1 ohm. With the ability to push your subwoofers to their limits, it provides deep, impactful bass that enhances your music experience. The SX1250.1 features a variable low-pass crossover, allowing users to fine-tune the cutoff frequency to perfectly match their subwoofers. Additionally, it is equipped with a built-in subsonic filter, which helps to eliminate unwanted lower frequencies that can lead to distortion.

The SX1250.1 utilizes advanced technology such as the Kicker's exclusive FIT (Fail-Safe Integration Technology), ensuring maximum compatibility with a variety of vehicle audio systems. This technology also aids in minimizing voltage loss and maximizing sound quality, resulting in an impressive audio output. The amplifier's thermal and short-circuit protection circuitry guarantees reliable performance, preventing overheating and ensuring longevity.

On the other hand, the Kicker SX650.1 is another exemplary model that emphasizes versatility and efficiency. This mono amplifier delivers 650 watts RMS at 1 ohm, making it suitable for smaller systems where space and power consumption are of concern. The SX650.1 also includes a variable low-pass crossover and bass boost feature, allowing users to customize their audio settings to suit their listening preferences.

Like its larger counterpart, the SX650.1 is built with FIT technology, ensuring a secure connection to your vehicle's audio system. Its compact design makes it easy to install in tight spaces without compromising on performance. Kicker has also included an integrated heatsink design to enhance cooling efficiency, ensuring optimal performance even during prolonged use.

Both the SX1250.1 and SX650.1 amplifiers boast a stylish and sleek appearance, with a distinctive Kicker logo that complements any audio setup. Whether you are a bass enthusiast seeking high-performance output or a casual listener looking for quality sound, the Kicker SX amplifiers deliver exceptional audio experience that is hard to match, making them a wise investment for any car audio lover.