Radio Operation
Listening to the Radio
1.Push the “POWER” button (1) once to turn the unit on.
2.Press the “BAND” button (12) to select a radio band: FM1, FM2, AM or WX (weather band).
3.AM or FM Station Selection
Automatic Seek Station Selection: Press the
or 
button (5) to automatically seek the next strong station.
Scan Station Selection: Press the SCAN button
(4)to automatically scan through strong sta- tions in the current radio band. The radio will pause for 5 seconds at each strong station. Each frequency will flash in the display. Press the scan button again to hold the current station.
Manual Station Selection: Press the 
or 
button for more than 3 seconds to manually select stations, and "MAN" will appear in the dis- play. Use either button to manually seek up and down the frequency scale.
Note: If either button is not pressed for several seconds, the unit will return to Automatic Seek Station selection and "AUTO" will appear in the display.
Weather Band Station Selection (WX)
Press the “BAND” button four times to select
WX, then use the 
or 
button to manually seek the stations.
Programming the Radio
You can program up to 20 FM radio stations and 10 AM radio stations.
Manual Station Recall Programming
1.Press the “BAND” button (12) to select a radio band: FM1, FM2, or AM.
2.Select the desired station.
3.Press and hold one of the ten station recall but- tons
4.Repeat the Steps
Automatic Station Store
1.Press the “BAND” button (12) to select a radio band: FM1, FM2 or AM.
2. Press the 
AS/PS button (14) for more than 2 sec- onds, the radio will then search the current fre- quency and check the signal strength until the six strongest stations are stored into the correspond- ing preset number button. When completed, the system will scan the stored stations automatically.
Preset Scan
Press the
AS/PS button (14) to scan the preset sta- tions. The radio will hold at that preset number for several seconds, then will scan again. To stop scanning when a desired station is reached press the
AS/PS button again.
Sound Controls
Adjusting the Volume, Bass Treble, Balance and Fader
1.Press the 
button (2) to select the desired audio mode. The audio modes will be displayed in the following order: Volume, Bass, Treble, Balance and Fader.
2.Press the 
or 
buttons (5) to adjust the sound of the audio mode selected.
Initial Volume Level
To program the Initial Volume Level, adjust the volume to the desired level, then press the "POWER" button for more than 3 seconds. The next time the unit is turned on, the volume will be at this initial level.
Adjusting the Audio Beep
Press the 
button for more then 2 seconds to turn beep On/Off. When the beep is on the
icon will be displayed.
Adjusting the Loud Feature
Press the LOUD button (15) to increase the bass and treble output, "LOUD" will then be displayed. Press the button again to release this function.
Mute
In Radio/Aux In mode, press the MUTE button (18) mute audio level. Press the button again to release this function.
4