Trouble Shooting

Sheet Metal

Before going through the trouble shooting table below, check the wiring connection. If the problem persist, consult your nearest service dealer.

SYMPTOM	CAUSE	SOLUTION

No power	The ACC Power Supply is not	Both the red and yellow
	connected.	wires require power from the
		power source.
	The fuse is blown.	Replace the fuse.

Disc cannot be loaded,	Presence of disc inside the player.	Remove the disc in the player, and
played or ejected		replace it with another disc.

	Disc was inserted upside down.	Insert the compact disc with the
		label facing up.
	Compact disc is extremely dirty or	Clean the disc or try playing a
	disc is defective.	another disc.
	Temperature inside the unit is	Allow the unit to cool off,
	too high.	then try again.

	Condensation.	Leave the player off for an hour, then
		try playing it again.
No sound.	Volume is set at the minimum level.	Adjust volume to the desired level.
	Speaker wiring is not properly connected.	Check the wiring connection.
Sound skips.	The installation angle is more	Adjust the installation angle to less
	than 30 degrees	than 30 degrees.

	Compact disc is extremely dirty or	Clean the disc or try playing a
	disc is defective.	another disc.
The operation keys	The built-in microcomputer	Press the RESET button.
do not work.	is not operating properly	Front panel is not properly fixed
	due to noise.	into its place.
The radio does not work.	The antenna cable is not connected.	Insert the antenna cable firmly.

The radio station automatic	The signals are too weak.	Select a station manually.
does not work.