Installation

Remove Transportation Screws

Before installing the unit, remove the two screws shown in the illustration below.

Remove Transportation

Screws Before

Installation

Note: If this unit is to be installed in a boat or a spa, you should use the two pieces of plastic film (30 mm X 20 mm) supplied to seal the two holes after removing the screws.

Installing the Unit

1.Using the mounting paper template supplied with the unit, determine the mounting location and then stick the template on the location.

Mounting Surface

Template

2.Cut and remove the hatching area on the tem- plate. Then drill four 1/8" mounting holes in the exact position according to the mounting paper.

Mounting Surface

Mounting

Location

Mounting

Holes

3.Use the glue paper to stick the two mounting brackets to the back of the mounting surface. The screw holes of the brackets must respec- tively aim at the mounting holes in order to fix the unit to the mounting surface.

4.Open the two pieces of rubber cover on the unit

Mounting	Mounting
Brackets	Surface

to display the four screw holes then using four screws (M4X30) to mount the unit to the dash- board.

Mounting Surface

Rubber

Cover

Screws

Rubber Cover