Kramer Electronics user manual Connecting the VA-4

Page 10

4 Connecting the VA-4

i

Always switch off the power to each device before connecting it to your

VA-4. After connecting your VA-4, connect its power and then switch

 

on the power to each device.

To connect the VA-4as illustrated in the example in Figure 3:

1.Connect a balanced stereo audio source (for example, a set top box: source 1) to the left and right channel 1 IN XLR connectors.

2.Connect a balanced stereo audio source (Source 2) to the left and right channel 2 IN XLR connectors.

3.Connect the left and right channel 1 OUT XLR connectors to a balanced stereo audio acceptor (Acceptor 1).

4.Connect the left and right channel 2 OUT XLR connectors to a balanced stereo audio acceptor (Acceptor 2).

5.Connect a PC (or other control device) to the RS-232 9-pn D-sub port, if control via RS-232 is required (see Section 4.1).

6.Connect the power cord to the mains electricity (not shown in Figure 3).

7.Select the stereo channel (1 or 2) by pressing the SELECT button, and set the level using the + and – buttons (as required).

VA-4 - Connecting the VA-4

7

Image 10
Contents VA-4 Page Figures Introduction Getting Started Achieving the Best PerformanceRecycling Kramer Products Overview This section defines the VA-4Select Button VA-4 Dual Channel Balanced Stereo Audio Amplifier Rear Panel Connecting the VA-4 Connecting to the VA-4 via RS-232 To PC Technical Specifications Protocol VA-4 ProtocolVA-4 Hex Codes for Gain Control Attenuation VA-4 Hex Codes for Gain Control Amplification VA-4 Protocol Safety Warning