Fusion MS-AV700, MS-IP700 Selecting and setting up a zone, Enabled, SETTING UP THE 700 SERIES

SETTING UP THE 700 SERIES

ZONES

Zone 1 and 2 are powered by the on board Class-D amplifier. External amplifiers are required to utilize the 4 line outputs and 4 subwoofer outputs. You can pre-set the balance, volume limit, sub-woofer level and name for each of the four Zones available on the 700 Series. If required, you can also:

•Enable or disable Zones 2, 3 and 4 (Zone 1 is always enabled).

•Enable or disable volume control (Zones 3 and 4 only).

•Link Zones 1 and 2.

For further details, see instructions below.

Rotary

Encoder

Menu key

Selecting and setting up a zone

To select a Zone and modify its settings: 1. Press the Menu key.

2. Turn and then press the Encoder to select Settings > Zone.

3.Turn and then press the Encoder to select the Zone you wish to work with.

4.Use any of the following instructions to update settings for the selected Zone.

Enabled

Zones 2–4 can be disabled if required. This is useful, for example, if only two

Zones have been set up, as disabled Zones are not displayed in any screens when setting levels.

To enable or disable the selected Zone:

a.Select the Enabled menu item.

b.Press the Encoder to enable ( ) or disable ( ) the selected Zone.

c.Press any key to exit

40