
PROTECTIVE MATERIAL | ANTENNA |
(RED SIDE) | (UNDERSIDE) |
ADHESIVE
STRIP
ANTENNA
CABLE
RUBBER ANTENNA
CABLE COVER/TAIL
period, avoid car washes and other contact with the antenna and rubber antenna cable cover/tail.
RUBBER ANTENNA
CABLE COVER/TAIL
peel the yellow protective material from the |
| ||
adhesive strip and adhere the adhesive strip to the | VEHICLE | ||
rubber antenna cover/tail. Next peel the red | MOUNTING SURFACE | ||
protective material from the adhesive strip and | Connecting the Receiver | ||
press the rubber antenna cable cover/tail firmly into | |||
Connect the antenna and cigarette lighter power | |||
place on the vehicle. | |||
adapter to the Receiver to complete the installation. | |||
Double check that the location of the antenna and | |||
The illustration below shows the location of the | |||
rubber antenna cable cover/tail are correct, and | |||
antenna and power connectors on the Receiver. | |||
continue to press firmly down on rubber antenna | |||
Plug the cigarette lighter power adapter cord into | |||
cable cover/tail for another 30 seconds. | |||
your vehicle’s cigarette lighter, and turn the Receiver | |||
Note: At room temperature (68 degrees), maximum | |||
On by pressing the power button. Once you have | |||
adhesion usually occurs within 72 hours. During this | |||
verified that Receiver has powered on, you can | |||
|
| ||
10 |
|
| |
| SV1 Receiver User and Installation Guide |