E Maintenance
N
G
L
I
S To Prevent Damage to the System Exterior
H
| E |
| N |
| G |
| L |
Notes on Discs | I |
S | |
H |
70 | Do not apply pesticides, benzine, thinner or other volatile substances to the unit. |
|
Pesticide
71 |
The cabinet surface primarily consists of plastic materials. |
Do not wipe with benzine, thinner or similar substances because this will result in |
discoloration or removal of the paint. |
When a cloth with a cleansing chemical is used, follow the caution points. |
Do not leave the unit in contact with rubber or vinyl products for long periods of |
time. |
Alcohol
Thinner
Wax Tape
Label side |
Do not use cleansers which have polishing granules because this could damage |
the surface of the unit. |
Benzine Adhesive Tape
Clean Dirt by Wiping Lightly with a Soft Cloth
When the unit is dirty, wipe the surface of the display using the Wiping Cloth (supplied).
Wipe lightly.
TILT | OPEN / CLOSE |
|
|
|
|
|
| OPEN / CLOSE |
|
|
|
| TILT | ||
|
|
|
|
| ||
|
| TRACK/ | ||||
|
| CHANNEL | ||||
OPEN |
|
|
|
|
| ENTER |
|
|
|
|
|
| DISC |
VOLUME | MUTE | NAVI | DISP | MODE | ASP P·MODE | SD CARD |
|
| NAVIGATION |
| POWER | ASPECT |
|
■Without a Wiping Cloth
When the unit is dirty, wipe with a
(Since there is the possibility of water drops getting inside of the unit, do not directly apply cleanser to the surface.)
Note: Do not scratch the screen with your nails or other hard objects. The resulting scratches or marks will obscure the image.
Caution: If water drops or similar wet substances get inside the monitor, it may cause a malfunction.
Product Servicing
If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized Panasonic Servicenter. The product should be serviced only by a qualified technician.
Replacing the Fuse
Use fuses of the same specified rating (5 A for display unit, 15 A for
If the replacement fuse fails, contact your nearest Panasonic Servicenter for service.
86
How to hold the disc
¡Do not touch the underside of the disc. ¡Do not scratch the disc.
¡Do not bend disc.
¡When not in use, keep disc in the case.
Do not use irregularly shaped discs.
Disc insert
The surfaces of new discs tend to be slippery. Therefore, when using such a disc for the first time, it may not load satisfactorily even when it has been inserted into the main unit. At a time like this, insert the disc into the main unit as far as it will go until it is loaded properly.
Do not leave discs in the following places:
¡Direct sunlight ¡Near car heaters
¡Dirty, dusty and damp areas ¡On seats and dashboards
Do not use irregularly shaped discs.
<Right><Wrong>
Disc cleaning
Use a dry, soft cloth to wipe from the center outward.
Do not attach any seals or labels to your discs.
Do not write on the disc label with a heavy pen or ballpoint pen.
Notes on
¡You may have trouble playing back some
¡The unit may not successfully play back a
¡This player cannot play
¡This player cannot play
87