Panasonic CY-VHD9500U Do not damage the cords, Run the cords so that they do not get, No Warranty

Page 5

E N G L I S H

Safety Information (continued)

 

 

 

 

G

 

 

 

 

 

E

 

 

 

 

 

N

 

 

 

 

 

L

 

 

 

 

 

 

 

 

 

 

I

 

 

 

 

 

S

Cautions At the time of operation or installation

 

Cautions

At the time of installation

 

 

 

H

Caution for replacing the bulb of the dome light

 

Caution for electrical connections:

 

 

 

 

 

 

Ask a qualified specialist to do this job.

While you are replacing a bulb, be absolutely sure to keep the dome light switch at OFF. Otherwise, you may burn yourself.

The bulb is very hot to the touch while it is lighted and immediately after it has gone off. Before attempting to replace it, turn the dome light switch off, wait several minutes and then check that it cooled off.

To prevent damage to the unit, be sure to follow the connection diagram. Do not connect the power connector to the unit until the wiring is completed.

When connecting stripped wires, be sure to wrap them securely with electrical tape to prevent shorts.

Bundle all cables and keep cable terminals free from touching any metal parts.

Use a bulb with the specified ratings (12 V/5 W). Do not use any other bulb.

Gripping the bulb with too much force may break it. Wear fingerstalls or use some other anti-slip method when replacing it.

Wear gloves for installation work to protect yourself from injuries.

Wear goggles or protective eyewear to shield your eyes from airborne metal particles during drilling.

If an RCA or similar cord is to be connected to the product, adjust its position and length so that it will not become entangled or come into contact with your body. After use, be absolutely sure to disconnect it from the product.

Failure to heed this caution may result in an accident and/or injury.

Before connecting the product with another device, consult the operating instructions of the device concerned to ensure that the product and device will be connected properly.

Incorrect connections may cause accidents and/or malfunctioning.

Failure to heed this caution may result in an accident and/or injury.

Take care that the wiring is not pinched or caught by the base plate attached to the roof or any other parts.

Failure to heed this caution may result in an accident and/or injury.

Failure to heed this caution may result in an accident and/or injury.

As you cut the headliner, take care not to cut your fingers. Also take care not to damage any other areas of the headliner.

Failure to heed this caution may result in an accident and/or injury.

Cautions

At the time of installation

Do not damage the cords.

Wire breaks and short circuits can cause electrical shock or fire.

Run the cords so that they do not get

tangled in the moving parts (such as Forbidden the seat rails), screws or car body.

Do not damage, pull too hard, fold, twist, or work on the cords. Do not place the cords near heating appliances or put heavy objects on the cords.

Take care not to injure your fingers with the power drill or other tool you are using. Also take care not to damage the wiring near the ceiling panel.

Failure to heed this caution may result in an accident, injury and/or malfunctioning.

Before installing the unit, be absolutely sure to check that the screws do not make any contact with the ceiling panel.

If some space is required between the base plate and the unit, attach and adjust the under cover. For details on installing the under cover, consult your dealer.

Install the monitor in a position where it will not hit anybody’s head when it opens and closes.

Failure to heed this caution may result in an accident and/or injury.

8CY-VHD9500U

Do not poke your fingers between the ceiling and this product.

Failure to heed this caution may result in an injury and/or malfunctioning of the product.

Forbidden

NO WARRANTY

Panasonic shall have no liability for reduction in safety or any accident caused by installing this product. We shall not guarantee any auto parts damaged during installation.

CY-VHD9500U9

Image 5
Contents CY-VHD9500U Installation Instrunctions Safety InformationDo not leave the remote control unit lying around Operating InstrunctionsFollow the instructions to install and wire the product Have a professional technician wire and install the productUse in DC 12 V grounded vehicles Do not disassemble, repair or modify the productWhat to do if a battery has leaked R03, AAA, UM-4 dry cells Use the product at the proper volume settingProper Use of the Batteries Do not play discs in the wrong or damaged formatRun the cords so that they do not get No WarrantyDo not damage the cords Dimmer Sensor HeadphonesWhen not Using the Product Safety Installation Diagram FeaturesSimple system Region Management InformationFollowing discs cannot be played back on this product CY-VHD9500UContents AccessoriesName of Controls Concerning volume level adjustmentsMain Unit Main Unit rearRemote Control Unit Close the Display Unit Remote Control Unit PreparationBattery Installation Battery Notes Battery Installation IR Wireless Headphones PreparationHow to Use the IR Wireless Headphones Operations Power and Volume Use of RangeGeneral PowerSource OSD On-Screen DisplayDisc Eject Disc InsertPlayback Stop Go to Beginning Pause Slow Playback Repeat PlaySwitching the Audio SwitchingSwitching between DVD MenuScan Play Folder Selection Direct Track/File/Folder Playing Discs CD/MP3Random Play Supported file systems and file names Points to Remember When Recording an MP3 DiscMaximum number of files/folders Example where a video game is connected to VTR2 VTR1/VTR2 ModeVTR Game etc VCR/CamcorderRecording to an SD Card on a PC Playing SD Cards0001.JPG ImgaMode Selection SD ModeConcerning the Data on the Cards SD Card InsertSetting Display during Moving Picture Playback Setting Repeat during Moving Picture PlaybackMusic file list screen Example Setting Repeat during Music PlaybackPlaying Voice Recordings Recorded on SD Cards Voice Playing Back Still Pictures PictureDimmer SettingBrightness MenuOther User Settings Finish the setting DVD video SettingsDVD Menu Language setting Display 2Select each Main MenuOn-Screen Messages Setting DVD Software modeNormal Aspect RatioFull ZoomTroubleshooting Tips TroubleshootingPreliminary Steps If You Suspect Something WrongSD card Display settings Error Display MessagesRemote Control Unit DVD video/Video CD/CD/MP3Fuse Error Display Messages MaintenanceProduct Servicing Damaged or deformed discs How to hold the disc or cardDisc cleaning Other cases Menu Language, Subtitle Language, Audio Langage Language Code List Definition of TermsCustomer Services Directory After-sales Service for ProductsSpecifications IR Wireless HeadphonesDisplay Unit MP3Division of Matsushita Electric Puerto Rico, Inc. PSC