E | Monitor Position Adjustment | |||
GN | ||||
L |
|
|
|
|
I |
|
|
|
|
S |
|
|
|
|
| Open the Display Unit |
| Display Unit Lateral Angle | |
H |
|
| ||
7 |
| (PUSH OPEN) |
| Adjustment |
|
|
|
| |
|
|
|
| |
Maximum 120e
30e
30e
1Push the display release button (PUSH OPEN) | You can swivel it to the left and right, 30˚ each way. | |
until the display is unlocked. | Hold the display unit by the | |
(Press the button with one hand while holding | ||
upper half of it and adjust its lateral angle. | ||
the display with the other.) | ||
| ||
2Open the display unit by both hands until a |
| |
comfortable viewing angle is reached. |
|
Close the Display Unit
Move the display unit by both hands until the display release button is locked.
Note:
≥Always use both hands to open or close the display unit.
≥Always check that the display release button is locked after closing the display unit.
≥If the display unit cannot be locked, be sure to consult your dealer and remedy the situation.
50CY-VHD9500U
Remote Control Unit Preparation | E | |
G | ||
|
| N |
|
| L |
|
| I |
Battery Installation | Battery Notes | S |
H | ||
1 Remove the battery holder. | ≥Battery type: Panasonic lithium battery | 8 |
With the remote control unit placed on a flat | (CR2025/1F) (supplied) |
|
surface: | ≥Battery life: Approximately 6 months under |
|
1 Stick your thumbnail into the groove, and | normal use (at room temperature) |
|
push the holder in the direction of the arrow, |
|
|
and at the same time | Caution: |
|
2 Pull it out in the direction of the arrow using |
| |
a tough pointed object. | ≥Improper use of the battery may cause |
|
| overheating, an explosion or ignition, resulting |
|
Tough pointed object | in injury or a fire. Battery leakage may damage |
|
Back side | the product. |
|
≥Do not expose the remote control unit to direct |
| |
|
| |
| sunlight. |
|
| ≥Do not recharge, disassemble, deform or heat |
|
| the battery. |
|
| ≥Do not put the battery in fire or water. |
|
| ≥Immediately replace used up battery. |
|
| ≥Obey local ordinances when disposing of the |
|
| battery. |
|
| Note: |
|
| ≥To ensure that the remote control unit is not |
|
| lost or misplaced, use the accessory magic tape |
|
| (“Velcro”) to secure it at a safe place. |
|
1 |
|
|
2 |
|
|
| magic tape (“Velcro”) |
|
2Install the battery on the battery holder. | (supplied) |
|
|
| |
Set a new battery properly with its (+) side facing up as shown in the figure.
3Insert the battery holder back into its original position.
Lithium battery (supplied)
≥Remove all oil, water, surfaces where the magic tapes are to be attached.
2
3
Battery holder |
| 51 |
|
| |
|
|
|