KEN.4064 H2EReceiver/Car Man 11/19/04 9:44 AM Page 16
•If composer information is available for a channel, it will be displayed along with the artist information.
2.Use the Control Knob (or the remote CH buttons) to move through the list of artists.
163. When the artist you want to hear is highlighted, press the Control Knob (or the remote Select button) to listen to them.
•After you make your selection, the display will revert to the Default Display screen.
Selecting Music by Song (Song List Mode)
1.Press and hold the Display button (or press the List button on the remote) while in the Default Display screen, then press the Display button (or the remote Display button) until a list of songs is shown. The Song List screen will appear, showing all
•Song titles too long to fit on highlight bar will scroll.
2.Use the Control Knob (or the remote CH buttons) to move through the list of songs.
3.When the song you want to hear is highlighted, press the Control Knob (or the remote Select button) to listen to it.
•After you make your selection, the display will revert to the Default Display screen.
Note: In the Channel List, Artist List, and Song List Modes, if you don’t want to make a selection, press and hold the Control Knob for 2 seconds on the front panel (or press the Back button on the remote) to exit the mode and return to the Default Display screen for the active channel.
Setting/Using
Channel Presets
Setting Channel Presets
You can store up to 30 of your favorite channels as presets for quick access. Presets are stored in 5 banks, labeled A through E, on the lower
1.Press the Band button to activate the preset bank you want. The selected bank and Preset is shown in the lower right corner of the Default Display screen. For example, this picture shows
If the current channel is not stored as a Preset, the Preset bank will be displayed alone in the same space.
2.Select the channel you want to preset (see Basic Operation and Selecting Channels, pg. 14).
3.Hold the number button you want to store the channel in for at least 2 seconds (or, using the remote, press the Preset button and press the number button you want to store).
•The selected preset number will flash and then remain lit on the display to show that it has been memorized.
•A beep will also be heard to confirm that the preset has been stored.
•If the preset button already has a channel stored in it, it will be replaced with the new channel.
Tuning Channel Presets
The 6 Presets in the active bank can be selected by pressing the
1.Press the Band button to cycle through the five banks of Preset stations. The display will show the current Preset bank and active Preset number in the lower right corner.
2.When the desired Preset bank is displayed,
use the | 17 |
Preset channel. |
|
|
Tuning Only to Preset Channels (Preset Tune Mode)
You can limit tuning to only the channels you have stored as Presets.
Hold the Band button for at least 1 second (or press the P. Tune button on the remote) to enter the Preset Tune Mode. The display will change to highlight the active channel and the current Preset band.
Use the Control Knob (or the remote CH buttons) to move through the Presets. Each time you change a Preset, its number will appear on the display and the channel will play.