❐Final installation
Lead Connections
Connect all wires, making sure that each connection is insulated and secure. Bundle all loose wires and fasten them with tape so they won’t fall down later.
Congratulations! After making a few final checks, you’re ready to enjoy your mobile DVD player.
❐Final checks
1.Make sure that all wires are properly connected and insulated.
2.Turn on the ignition to check the unit for proper operation.
If you have difficulties, consult your nearest authorized professional installer for assistance.
❐Preparation
≥We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
≥Disconnect the cable from the negative - battery terminal (see caution below).
≥The product should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30o.
❐How to install the product
The diagram below shows an example in which this product is installed to the floor. Consult a qualified servicing engineer or your dealer for information on installing this product to a different location.
When installing the unit with the
1Attach the
CX-D3000U
3
2 4
(M5k6 mm)
2 Install the product with tapping screws 1.
1 4 tapping screws 
(5 mm·k16 mm)
E
N
G
L
I
S
H
30
Less than 30x
Caution:
≥Do not disconnect the battery terminals of a car with a trip or navigational computer since all user settings stored in memory will be lost. Instead take extra care with installing the unit to prevent shorts.
If you plan to attach the product to the floor, avoid dusty locations.
Caution:
≥All other installation methods required the use of dedicated metal fittings. Consult with a qualified servicing engineer or your dealer if other methods are required.
≥When drilling holes in the car, make sure that you do not damage any pipes or wiring on the underside of the car.
≥When installing the product, make sure that the cord is positioned in a location where it will not pinched or damaged when the seat slides forward or backward.
39