Panasonic CQ-VD6505W manual Center ting, AV1 Level, AV2 Level, Adjusting the output balance

Page 35

Note:

¡While the private mode is active, only

FRONT L and

FRONT R can be

adjusted.

TEST TONE (Test tone output)

ON : enables the test tone.

OFF : disables the test tone.

default: OFF

¡When the test tone is set to on, test signal (a continu- ous tone) is output from each speaker for approximately 2 seconds.

Adjust the output balance so that the tone appears to have the same volume from each speaker.

Adjusting the output balance:

Adjust the volume of all of the other speakers to the vol- ume level of the speaker from which the test signal appears to be the quietest.

TIME ALIGNMENT

(Delay time setting of each speaker)

Adjusting the timing with which the audio from each speaker reaches the listener’s position

(Center speaker delay time set-

CENTER ting)

]

: down,

[

: up

 

 

Setting range: 0 ms to 5 ms (1 ms steps)

 

 

 

 

1 ms = 0.001 seconds

 

 

 

 

default: 0 ms

 

 

 

 

(Surround speaker delay time

 

SUR

 

 

 

 

 

setting)

 

: down,

 

: up

]

[

 

 

Setting range: 0 ms to 15 ms (1 ms steps)

1 ms = 0.001 seconds default: 0 ms

¡Make this adjustment while listening to sound. ¡If the speaker setting is NONE for a speaker, that

speaker cannot be selected.

¡When “PRO LOGIC” is displayed, 15 ms are automatically added to the delay time setting for the surround speakers.

English

SOURCE LEVEL

34

Setting the AV1/AV2 input level

Make this setting if it is not possible to adjust the volume through the connected device (on the output side).

AV1 LEVEL

(Setting for AV1)

 

: sets the level low/sound volume increases.

LOW

 

: sets the level high/sound volume decreases.

HIGH

 

 

default:

 

 

 

HIGH

 

 

 

 

AV2 LEVEL

(Setting for AV2)

 

: sets the level low/sound volume increases.

LOW

 

: sets the level high/sound volume decreases.

HIGH

Note:

¡If the input level from AV1/AV2 is too high, the audio will not be output normally.

¡After setting the input level

The volume can be adjusted by pressing [+] or [–] (VOL).

 

 

 

 

 

default:

HIGH

 

 

 

 

 

 

 

 

CROSS OVER

 

 

 

Cut off frequency

 

 

 

 

 

 

LPF CUT OFF

 

(Sub-woofer Low Pass Filter)

 

: down,

 

: up

 

 

 

]

[

 

 

 

 

 

 

 

 

Setting range: 63 Hz to 200 Hz

 

 

 

 

 

default: 125 Hz

 

 

 

 

HPF CUT OFF

 

(High Pass Filter)

 

: down,

 

: up

 

 

 

]

[

 

 

 

 

 

 

 

Setting range: off, 63 Hz to 200 Hz

 

 

 

 

 

default: off

Note:

¡This setting is not available if CS Auto is set to ON .

¡HPF CUT OFF is enabled only on the front speakers (R/L) and rear speakers (L/R).

CQ-VD6505W

35

Image 35
Contents Model CQ-VD6505W Do not disassemble or modify the unit Use the proper power supplyDo not use the unit when it is out of order Protect the Deck MechanismTake care not to damage the leads Follow the instructions to install and wire the prod- uctInstallation Angle Case of battery leakageSafety Information Components Before Reading These InstructionsConnectable devices FeaturesContents Preparation Other SettingsRemote Control Unit Battery ReplacementDisc Marks Symbols used in this manualPictographs Name of Controls and Functions Return RET Return RETMute + VOL SRC PWR RETSource Button Touch Panel Operation OverviewState of Operation Screen Display ButtonShowing the hidden part of the screen Switching the displayHow to Call up Operation Screen Radio Disc Player DVD/VCD *1OFF GeneralGeneral Operations VOL VolumeMute Tilt AngleALL Before Disc PlaybackDiscs that can be Played Back Eject Disc Insert/EjectDisc Insert Disc EjectAudio Mode Disc Mode DVD SelectionVideo Mode VCD Video CD mode displayBasic Operations Chapter/title Selection Useful Function Common Displayed itemsDisplayable characters Copyright No warrantySupported file systems Maximum number of files/foldersRadio Radio Mode SelectionTuning Preset Memory AV1/AV2 on AV Mode Selection¡Connect an optional external device to the AV1/AV2 Touch Source Button. dEnglish Settings Menu Example setting screen of Display Unit aMenu Operation Tilt How to set your ID code for the first timeHow to change your ID code How to cancel the known ID codeACC Select Tint Adjusting level of each presetBright Color¡TruBass SelectTruBass MixingSUR PhaseFront CenterAV1 Level Adjusting the output balance¡After setting the input level Center tingAudio MenuSubtitle AV2 Skip PRO LogicDown MIX DR CompReceived to prioritize sound quality Setting for AM stations Noise Suppression Noise suppressionAspect Ratio Press and hold ASP Pmode on the main unit for Private Mode¡Be sure to set to OFF when you do not use the private mode ASP PmodeCommon TroubleshootingACheck the speaker wiring ASecure the unit to the console box Check the wiring of the antenna power leadRadio Disc is still unfinalized Disc has unplayable formatted dataThere is a flaw or foreign objects on the disc ¡Refer to Notes on MP3/WMA aPicture is whitish. Something Display SettingsPicture is dark. AConnect the cables correctly Sound settingsAConnect the speaker wires to the correct one CD/MP3/WMA/DVD/VCD Video CD Error Display MessagesCase you forget the ID code Maintenance ¡Discs with adhered labels, etc. on them Disc insert How to hold the discDisc cleaning DVD-Rs/RWsCode Language Name Language Code ListOther cases... a Interactive DVD Dolby DigitalDolby Pro Logic DtsSpecifications YFM284C681CA PTW0107-1027 Installation Instructions Safety Information Upgrade Options Installation Precautions InstallationDashboard Installation Installation OpeningDiagram Qty Before InstallationInstallation Hardware For Installation Installation Hardware For WiringMethod for Fixing the Rear of the Unit Mounting Procedures a When using Mounting Collar wMounting and removing the Main Unit When not using Mounting Collar w Mounting Procedures BRemoving Procedures Electrical Connections To the Panasonic Car Navigation System available in future RGB ConnectorRadio Antenna Connector Radio ANT System-up Connector To external devices equipped with system-up connectorSide Brake Parking Brake Connection Lead Hand brakeFoot brake Side Brake Parking Brake Connection Lead Bright greenCY-TUN133W option Connection with TV TunerCY-TUP133W Ground Lead Black DIN ConnectorCX-DH801W option CX-DP880 option Battery Lead YellowDIN Cord Black DIN Connector Conversion Cable for DVD/CD Connection with CD Changer CX-DP880CY-EM100N option Example Connection with Rear MonitorConnection with VCR or Camcorder OptionControl Unit option Connecting the Reverse LeadConnection with Rear View Camera Rear View CameraEnglish YFM294C102CA PTW0107-1027 System Upgrade Guidebook Safety Information Use the designated parts and tools for installation CY-TUP133W/CY-TUN133W, option IPod System upgrade sampleTV Tuner Rear Monitor Main Unit Connectable devices Hands-Free Kit featuring System-up Connector CD ChangerBluetooth technology Simultaneous Multi-Device ConnectionChannel Surround System Menu Setting, a Operating Instructions CD Changer a TV tuner *1 a DVD Changer *1 aTV Tuner Control TV Mode SelectionCalling Deleting Preset Writing PresetPreset Channel CD Changer Control CD Changer Mode SelectionDVD Changer Control DVD Changer Mode SelectionEnter Return Chapter/title/track SelectionDVD Menu d English Cannot send calls Bluetooth Hands-Free KitBluetooth Hands-Free Mode Source AdjustmentPhone receiver Volume Back to Previous Adjustment of RingTitle Scroll IPod Mode SelectionIPod Control Operation Screen Shuffle SongsShuffle Albums Standard ScreenConnection with Panasonic car navigation system DVD INPUT/OUTPUT RadioCamera AV1 When the Expansion Module CY-EM100N, option is disconnectedWhen the Expansion Module CY-EM100N, option is connected Default BothIPod is not ProblemIPod Control Picture from a rear View camera is not DisplayedNo magazine is in the changer CD Changer/DVD Changer ControlYFM284C682CA PTW0107-2037
Related manuals
Manual 94 pages 58.98 Kb