Clarion DXZ435 owner manual Case of Difficulty, Dcp

English

9. IN CASE OF DIFFICULTY

	Problem	Cause	Measure
	Power does not turn	Fuse is blown.	Replace with a fuse of the same amperage. If
	on.		the fuse blows again, consult your store of
	(No sound is pro-		purchase.
	duced.)
		Incorrect wiring.	Consult your store of purchase.
	No sound output	Power antenna lead is shor-	1. Turn the unit off.
	when operating the	ted to ground or excessive	2. Remove all wires attached to the power
	unit with amplifiers or	current is required for re-	antenna lead. Check each wire for a possible
	power antenna at-	mote-on the amplifiers or	short to ground using an ohm meter.
	tached.	power antenna.	3. Turn the unit back on.
			4. Reconnect each amplifier remote wire to the
General			power antenna lead one by one. If the
			amplifiers turn off before all wires are
			required).
			attached, use an external relay to provide
			remote-on voltage (excessive current
	Nothing happens	The microprocessor has	Turn off the power, then
	when buttons are	malfunctioned due to noise,	press the [RELEASE]
	pressed.	etc.	button and remove the
			DCP.
	Display is not accu-		Press the reset button for
	rate.		about 2 seconds with a
			thin rod.
			Reset button
		DCP or main unit connec-	Wipe the dirt off with a soft cloth moistened with
		tors are dirty.	cleaning alcohol.
	Compact disc cannot	Another compact disc is al-	Eject the compact disc before loading the new
	be loaded.	ready loaded.	one.
	Sound skips or is noi-	Compact disc is dirty.	Clean the compact disc with a soft cloth.
	sy.
		Compact disc is heavily	Replace with a compact disc with no scratches.
CD		scratched or warped.
	Sound is bad directly	Water droplets may form on	Let dry for about 1 hour with the power on.
	after power is turned	the internal lens when the
	on.	car is parked in a humid
		place.

10. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.

Take the measures described below to eliminate the problem.

	Error Display	Cause	Measure
	ERROR 2	A CD is caught inside the CD deck and is	This is a failure of CD deck’s mechanism and
		not ejected.	consult your store of purchase.
CD	ERROR 3	A CD cannot be played due to scratches,	Replace with a non-scratched, non-warped-
		etc.	disc.
	ERROR 6	A CD is loaded upside-down inside the CD	Eject the disc then reload it properly.
		deck and does not play.
	ERROR 2	A CD inside the CD changer is not loaded.	This is a failure of CD changer’s mechanism
changer			and consult your store of purchase.
	ERROR 3	A CD inside the CD changer cannot be	Replace with a non-scratched, non-warped
		played due to scratches, etc.	disc.
CD
	ERROR 6	A CD inside the CD changer cannot be	Eject the disc then reload it properly.
		played because it is loaded upside-down.
	ERROR H	Displayed when the temperature in the MD	Lower the surrounding temperature and wait
		changer is too high and playback has been	for a while to cool off MD changer.
		stopped automatically.
changer	ERROR 2	An MD inside the MD changer is not loaded.	This is a failure of MD changer’s mechanism
			and consult your store of purchase.
	ERROR 3	An MD inside the MD changer cannot be	Replace with a non-scratched, non-warped
		played due to scratches, etc.	disc.
MD
	ERROR 6	An MD inside the MD changer cannot be	Eject the disc then reload it properly.
		played because it is loaded upside-down.
		Displayed when a non-recorded MD is	Load a pre-recorded MD in the MD changer.
		loaded in the MD changer.
	ERROR 2	A DISC inside the DVD changer cannot be	This is a failure of DVD mechanism and
		played.	consult your store of purchase.
changer	ERROR 3	A DISC cannot be played due to scratches,	Retry or replace with a non-scratched, non-
		etc.	warped-disc.
	ERROR 6	A DISC inside the DVD changer cannot be	Eject the disc then reload it properly
		played because it is loaded upside-down.
DVD
	ERROR P	Parental level error	Set the correct Parental level.
	ERROR R	Region code error	Eject the disc and replace correct region
			code disc.

If an error display other than the ones described above appears, press the reset button. If the problem persists, turn off the power and consult your store of purchase.

English

24 DXZ435 DXZ435 25