8. IN CASE OF DIFFICULTY
| Problem | Cause | Measure |
|
| Power does not | Fuse is blown. | Replace with a fuse of the same amperage. If the | |
| turn on. |
| fuse blows again, consult your store of purchase. | |
| (No sound is |
|
|
|
|
|
|
| |
| produced.) | Incorrect wiring. | Consult your store of purchase. |
|
|
|
|
|
|
| No sound output | Power antenna lead is | 1. Turn the unit off. |
|
| when operating | shorted to ground or | 2. Remove all wires attached to the power antenna | |
| the unit with | excessive current is required | lead. Check each wire for a possible short to | |
| amplifiers or | for | ground using an ohm meter. |
|
| power antenna | or power antenna. | 3. Turn the unit back on. |
|
| attached. |
| 4. Reconnect each amplifier remote wire to the | |
|
|
| power antenna lead one by one. If the amplifiers | |
|
|
| turn off before all wires are attached, use an | |
|
|
| external relay to provide | |
|
|
| (excessive current required). |
|
General |
|
|
|
|
Nothing happens | The microprocessor has | Turn off the power, then | Reset button | |
| when buttons are | malfunctioned due to noise, | press the [OPEN] button |
|
| pressed. | etc. | and remove the DCP. |
|
|
|
| Press the reset button for |
|
| Display is not |
| about 2 seconds with a thin |
|
| accurate. |
| rod. |
|
|
|
|
| |
|
| DCP or main unit connectors | Wipe the dirt off with a soft cloth moistened with | |
|
| are dirty. | cleaning alcohol. |
|
|
|
|
| |
| No sound heard. | The speaker protection circuit | 1. Turn down sound volume. Function can also be | |
|
| is operating. | restored by turning the power off and on again. | |
|
|
| (Speaker volume is reduced automatically when | |
|
|
| the speaker protection circuit operates). | |
|
|
| 2. If the sound is muted again, consult our service | |
|
|
| department. |
|
|
|
|
| |
| No sound heard. | Another disc is already | Eject the disc before loading the new one. | |
|
| loaded. |
|
|
|
|
|
| |
|
| MP3/WMA files are absent | Write MP3/WMA files onto the disc properly. | |
|
| in a disc. |
|
|
|
|
|
|
|
|
| Files are not recognized as | Use MP3/WMA files encoded properly. |
|
CD/MP3/WMA |
| an MP3/WMA file. |
|
|
|
|
|
| |
| File system is not correct. | Use ISO9660 level 1, 2, 3 or JOLIET or Romeo file system. | ||
|
| |||
|
|
|
|
|
| Sound skips or is | Disc is dirty. | Clean the disc with a soft cloth. |
|
| noisy. |
|
|
|
| Disc is heavily scratched or | Replace with a disc with no scratches. |
| |
|
|
| ||
|
| warped. |
|
|
|
|
|
|
|
| Sound is cut or | MP3/WMA files are not | Use MP3/WMA files encoded properly. |
|
| skipped. | encoded properly. |
|
|
| Noise is |
|
|
|
| generated or |
|
|
|
| noise is mixed |
|
|
|
| with sound. |
|
|
|
|
|
|
|
|
English
DXZ738RMP 35