Trouble Shooting
Reactor does not power up.
1)Is the power cord properly plugged into an electrical outlet?
2)Is there power at the outlet?
3)Is the power cord firmly inserted into the AC input socket on the rear panel?
4)Is the fuse blown?
The Reactor powers up but the modeler does not.
1)Is the Dock power cord the correct match to the modeler?
2)Are the connectors on the ends of the power cable properly connected to the Dock and modeler power input?
3)Is the modeler power switch in the “ON” position?
The Reactor and the modeler power up but no sound.
1)Is the output level control on the modeler turned up?
2)Is the guitar cable defective?
3)Are the Dock input and two output cables properly connected to the modeler?
4)Has a quarter inch phone plug been left plugged into the Return jack?
5)Is the Dock properly inserted into the Reactor? See warning on
If none of the above checks have found the problem,
The next step Is to narrow down the possibilities by determining whether the malfunction is in the Reactor amp/speaker system or in the Docking System. You can do this by plugging your instrument into The Return Jack, if the instrument can be heard it would indicate that the problem is with the modeler, the modeler installation, the Dock insertion or a defective Dock.
If after checking all of the above your Reactor 112 is still not performing correctly, consult your authorized Atomic Service Center or call the Atomic Amplifier support line
(See Obtaining Service next page)
16