Atomic 112 owner manual Expanding Your Rig, Installing a Blank Template into the DS-1

Expanding Your Rig

Installing a Blank Template into the DS-1

XFirst locate the 8 screws attaching the template frame to the top of the DS- 1. There are 4 screws that come in groups of 2 on each side. Remove these screws (and don’t lose them!) using a properly sized Phillips-head screwdriver.

YRemove the template frame of the DS- 1

Still got the screws?

ZReplace the template frame with a blank template (Atomic Part # ATBLANK –

purchased separately).

Still got the screws?

[Replace the 8 screws. (Whew!) You can now load the DS-1 into the Reactor as usual *.

The Reactor is now ready to be used with a Pro-rack or foot controller style modeler

*NOTE! When bypassing the DS-1, the “RETURN” input on the rear jack panel of the Reactor 112 should be used as the Reactor’s main input, (see pages 11-14). Inserting a jack into the RETURN puts the Reactor in “Direct Mode” and automatically cancels out the open audio cables from the DS-1.

8