Controls & Connections Top, Power

Controls & Connections (Top)	[
X Z	\
	\
	^

Y ]

XPOWER:

The power switch turns the power OFF & ON to the Reactor 112. It also acts as the master power switch for the modeler when connected and housed in the DS-1 (see page 6).

YINPUT:

This is where you plug in your instrument cable when docking a modeler inside the DS-1. NOTE! When using a modeler outside of the DS-1, such as a Rack-mount or floor based modeler, the instrument should be connected to the modeler per the modeler’s instruction manual.

ZCOOLING VENT:

The cooling vent is located directly above the tubes and in conjunction with the studio quiet fan (page 4 – item “6”) does an excellent job of keeping the Reactor cool. No matter how hot the playing.

KEEP THE COOLING VENT OPEN AND FREE OF OBSTACLES!

[DOCKING BAY:

This is the mechanism in the Reactor 112 designed to house the DS-1 Docking Unit.

\MULTI-PIN CONNECTOR & KILL SWITCH:

The MULTI-PIN connector provides the audio & power to and from the dock and the Reactors electronics. The KILL SWITCH helps eliminate “POPS” and allows the DS-1 to be removed and reinserted without the user having to turn off and on the power switch on the Reactor 112.

]DOCK LOCKS:

This is where the dock “locks” into place. To release the DS-1 from the Reactor, just push the handles located on the sides of the DS-1 towards the center and pull up on the dock.

^INDENTATIONS:

Three circular indentations accommodate the thumbscrews on the DS-1 docking unit (page 6).