Congratulations on your purchase!
Your new high fidelity bridgeable/stereo amplifier is designed to deliver maximum enjoyment and one year of trouble free service. Please take a few moments to read this manual thoroughly.
It will explain the features and operation of your unit and help insure trouble free installation.
Features
CLASS ''D''
-Fully 1 Ohm Stable Operation
-Military Spec Audiophile Grade Components
-High Efficiency PWM Power Supply
-
-Two Torroidial Core
-MOSFET Transistors
-Over Sized Capacitor Banks
-Master / Slave Capability
-Discrete Mount Power & Speaker Terminals
-Varible Lowpass Electronic Crossover
-Varible Subsonic Filter
-3way Protection Circuitry
-Soft Remote On/off Circuitry
-Digital Subwoofer Level Control
Precautions: Read First!
-If after reading the direction you feel uncomfortable about installing the amplifier in your car, or not equipped or competent to do so, you should have the amplifier installed by an authorized installer. It's your car!
-Negative battery terminal must be disconnected before any electrical connection are made.
-Be sure choose a location that provides substantial ventilation for the amplifier. The most preferred locations would be in your car's trunk or on the back wall of a truck.
-The location chosen should provide at least 4" of clearance above the amplifier for adequate ventilation.
-If the amplifier is to be mounted vertically be sure that it is in a place where adequate air will flow along the length of its heatsink fins for cooling.
-NEVER mount the amplifier up side down, this will cause the heat to rise back into the amplifier causing thermal shutdown or possible permanent damage.
-NEVER mount the amplifier in a location that is subject to direct sunlight or exposed to moisture.
1