Kenwood SYSTEM-H2EV installation manual Time Features, Alarm Clock, Program Alert

KEN.4061 ReceiverCarHome Manual 11/19/04 9:37 AM Page 28

Time Features

This menu option allows you to control the clock, alarm, program alerts, and other features that use Here2Everywhere’s internal clock.

28Here2Everywhere has an internal clock which auto- matically picks up Universal time from the SIRIUS broadcast. After you set the Timezone and Daylight Savings Time features, the clock will always keep accurate time. However, the clock does require the SIRIUS signal after the unit is connected to power each time before it is valid. After you dock or power Here2Everywhere, allow a few seconds to acquire the clock signal.

The Time Features menu option presents the following submenu choices:

•Clock

•Alarm Clock

•Program Alert

•Auto Shutdown

•Sleep Mode

Clock

Selecting this menu option allows you to setup the clock that is shown on the default display.

The following options appear in this submenu:

•Format

•Time Zone

•Daylight Savings Time

Pressing the Select button enters the selected sub- menu. Pressing the Menu button returns to the Time Features submenu.

Clock: Format

This option allows you to select between 12-hour format, and 24-hour format.

Clock: Time Zone

This option allows you to select one of the following time zones:

•(GMT -9:00) Alaska

•(GMT -8:00) Pacific (Factory Default)

•(GMT -7:00) Mountain

•(GMT -6:00) Central

•(GMT -5:00) Eastern

•(GMT -4:00) Atlantic

•(GMT -3:30) Newfoundland

Clock: Daylight Savings Time

This option sets whether or not your location observes daylight savings time (not whether DST is in effect— this is transmitted in the SIRIUS broadcast).

Alarm Clock

This menu option allows you to set Here2Everywhere to turn itself on at a selected time, or, if the unit is already on, beep and flash the display. The last active channel prior to shutdown will be activated when the Alarm goes off.

The submenu below gives you two options:

•Set Alarm (or Clear Alarm, if it is already set)

•Alarm Time

Alarm Clock: Set Alarm

This option allows you to enable or disable the alarm, itself.

Note: When the alarm function is enabled, the clock on the default screen will be highlighted.

Alarm Clock: Alarm Time

In this mode, you can change the alarm time as follows: Use the Control Knob (or the remote CH buttons) to select the hour. Press the Control Knob (or the remote Select button) to save the hour, and move the selection to the minutes. Use the Control Knob to select the minutes, and press the Control Knob (or the remote Select button) to save it. Use the Menu button to cancel changes and exit back to the Alarm Clock submenu.

Note: If Here2Everywhere is off (but with power, while
in the Home Docking cradle) when the alarm time
comes, it will power itself on and present the option,
“Press Band to Snooze”. The Snooze option is a
9-minute delay until the alarm goes off again. Also,
you can press the Power ( ) button to cancel the	29
alarm and shut Here2Everywhere back off or any
other key to simply cancel the alarm and go to music.

Program Alert

This submenu option allows you to have Here2Everywhere alert you when a favorite program is scheduled to start. You can set the program time and channel number in advance, and Here2Everywhere will let you know at the appropriate time.

This submenu presents several options:

•Program Time/Day

•Channel Number

•Program Alert On/Off

Program Alert: Program Time/Day

Use this selection to enter the date and time of the preferred program.

Program Alert: Channel Number

Use this selection to enter the channel of the preferred program.