P-2 Installing the monitor
Carry out as necessary
Installing and removing the stands
The stands are available as option.
Refer to the user’s manual of the stand for more information.
Screw x 2 (Accessories of the option stand)
Option stand x 2
(Longer portion comes to the front.)
How to install the stands
1.Turn the monitor off.
2.Fasten screws on both sides of the monitor.
NOTE:
Install the stands so that their longer portions come to the front.
How to remove the stands
1.Spread the protective sheet on a flat surface, such as a desk.
2.Place the monitor on the protective sheet.
3.Remove the screws with a screwdriver and place them in a safe place for reuse.
Installing the main switch cover
To prevent unauthorized operation of the main power switch, attach the main switch cover, which is supplied as an accessory.
NOTE:
With the main power switch cover in place, the main power switch cannot be turned off. Remove the main power switch cover in order to switch off the monitor.
Screw x 2 (Accessory)
Main switch cover (Accessory)
Using the wall mount or ceiling mount
Lay the screen face down
Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen surface.
This device cannot be used or installed without the Tabletop Stand or other mounting accessory. Failure to follow the correct mounting procedures can result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation.
Failure to follow these recommendations can void your warranty.
Use M6 screws (having a length 10 mm longer than the thickness of the mounting bracket) and tighten them securely. Prevent the screws from loosening using spring washers, etc. MITSUBISHI ELECTRIC recommends using mounting interface that comply with
511.5 |
| 511.5 | Protective |
| Sheet | ||
100 | 100 |
| |
|
| ||
100 |
| 100 |
|
|
|
| 307 |
|
|
| 100 100 |
|
|
| 307 |
|
|
| (mm) |
Table |
| Tabletop Stand |
|
|
|
|
CAUTION:
For preventing the monitor from falling.
•Install the monitor with metal brackets for wall or ceiling installation (commercially available) on your own responsibility. For detailed procedures of installation, refer to the instructions of the metal brackets.
•To lessen the probability of injury and damage resulting from fall of the monitor in case of earthquake or other disaster, be sure to consult the bracket manufacturer for installation location.
•To lessen the risk of falling of the monitor, thread commercially available rope through the handles at the right and left of the monitor and secure the rope to the wall mount brackets or ceiling mount brackets.
•Do not sleep where the monitor may topple over or fall in case of an earthquake or other disaster.
Downloaded From | |
|