Dynacord DPA 4410 dimensions General Notes, Installation Notes, Amplifier has to be protected from

Page 5

1. GENERAL NOTES

The amplifier DPA 4410 has been specially designed to ensure durable performance and reliable operation of sound reinforcement systems with several independent speaker circuits. The DPA 4410 is best suited for call and message transmission installations, alert systems, and for general music applications in industrial enterprises, offices, multi-functional halls and sports arenas, schools, churches, hotels, hospitals, supermarkets, cruise ships, and other similar occasions.

2. INSTALLATION NOTES

When placing or mounting the amplifier, it is important that the air-flow can pass unhindered through the air inlets on the front and the air outlets on the rear of the appliance (see also paragraph 10).

The amplifier has to be protected from:

-dropping or splashing water

-direct sunlight

-high environmental temperatures or direct radiation of heat sources

-moisture

-dust

-shock or vibration

When moving the amplifier from a cold into a warm environment, condensation of its inner parts can sometimes occur. If so, the appliance can be operated again after gaining the environmental temperature (approximately after one hour).

If a solid object has fallen or liquid has leaked into the device, disconnect all connections and get in contact with an authorized DYNACORD service center. Do not operate the amplifier after such accidents.

When cleaning the amplifier’s outside enclosure, never use any cleaning sprays or detergents, because of inflamability. The use of those liquids will damage the appliance.

3. PRECAUTIONS AND RECOMMENDATIONS

When the appliance is operated with the mains supply, use the included mains cable to connect the amplifier to a 230 V or 115 V 50/60 Hz wall outlet. Connect the cable’s other end to the appliance’s 3-pole machine-type socket (10).

Warning The amplifier is factory-set to 230 V AC. To change this setting use the voltage switch (12). For the operation with 115 V AC, the mains fuse (11) has to be exchanged by an 8 A slow-blow fuse with the label print “T8A” (see also paragraph 11).

When using the amplifier with a remote-start device, an external 24 V DC source has to be connected to the REMOTE CONTROL connector (16) (see also paragraph 5.6). If the connection was performed right and 24 V DC voltage is present, the STANDBY indicator (4) will light.

The POWER switch (9) on the rear of the amplifier for bridging the starting relay is meant only for service purposes. In that case the amplifier can be operated without the external 24 V DC supply.

Note The POWER switch (9) on the rear of the amplifier is meant only for service purposes. If this switch is engaged, the remote power-off function of the appliance is not operational and the

STANDBY indicator provides no indication.

The DPA 4410 is equipped with a cut-in delay of approximately 3 seconds to efficiently suppress power-on noise.

21

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Features DPA 4410 Power AmplifierFor US and Canada only Safety Component has to be Replaced with Original Part onlyINDICATORS, Controls and Connections Table of Contents Precautions and Recommendations Installation NotesGeneral Notes Amplifier has to be protected fromHinweis Outputs Power OutputInputs 1 Power Output with low impedance speaker systems Power Output with 100 V speaker systemsRemote Control connection Power Output 100 V with double output capacity100 W or 2 x 100 W + 1 x 200 W or 2 x 200 W Monitor outputDC Operation MeteringNRS 90206 pilot tone surveillance Additional Functions and FeaturesNRS 90208 input transformer NRS 90207 ground fault surveillanceFuses Incorporation Into 19 Flightcases or 19 Rack SystemsPage Specifications of the DPA Specifications of the Optional Accessories Optional accessories for the DPANRS 90207 ground fault surveillance module for four outputs NRS 90206 pilot tone surveillance module for four outputs
Top Page Image Contents