Extron electronic MTP 15 HD A manual MTP 15HD a Series Installation and Operation

KDIP switches (RL receivers only) — A 5-pole DIP switch is used to configure the features of the MTP receivers.

•• Horizontal sync (H Sync +) switch — Set this switch On (up) for positive horizontal sync or Off (down) for negative sync.

•• Vertical sync (V Sync +) switch — Set this switch On (up) for positive vertical sync or Off (down) for negative sync.

NOTE: Most devices use negative sync for H Sync and V Sync.

•• S-Video switch — This switch is used to set which pins of the 15-pin HD connector S-video is output on.

•• Set this switch On (up) to output chroma on pin 3 and luma on pin 2.

•• Set this switch Off (down) to output chroma on pin 1 and luma on pin 2.

•• End Unit switch — Set this switch On (up) if either of the following is true:

•• The receiver being configured is the only receiver connected to the transmitter.

•• The receiver being configured is the last receiver in a daisy-chained system.

Set the End Unit switch Off (down) on the receiver being configured if there are one or more receivers connected to the Buffered Output RJ-45 connector (see

figure 6, C).

MTP 15HD A Series • Installation and Operation 8