Extron electronic MTP 15 HD A manual Mm Stereo Audio Plug

DAudio input connector — Plug a 3.5 mm stereo audio plug into this connector for unbalanced audio input. Wire the plug as shown in figure 5. The stereo audio input is

summed and output on the twisted pair cable as mono audio.

Tip

Left (+)

Ring

Right (-)

Sleeve ( )

Figure 5. 3.5 mm Stereo Audio Plug

EPre-Peak switch — The Pre-Peak switch alters the twisted pair signal output to correct for long cable runs (see the table on page 4 for suggested switch settings based on the transmitted video format and transmission distance).

FOutput connector — Connect one end of a twisted pair cable to this RJ-45 female connector on the transmitter. Connect the free end of the same twisted pair cable to the RJ-45 female connector on the receiver (see Twisted Pair Cable Termination on page 14 to wire the RJ-45 connectors).

ATTENTION: Potential damage to property.

Do not connect these devices to a computer data or telecommunications network.

MTP 15HD A Series • Installation and Operation 10