Extron electronic MTP 15 HD A manual Receiver Rear Panel Features

Receiver Rear Panel Features

Figure 6 shows an MTP RL 15HD A receiver, which has all of the connectors and other features that are on either receiver in the MTP 15HD A series.

MTP RL 15HD A

	BUFFERED	OUTPUTS
POWER
	INPUT OUTPUT	MONO AUDIO
12V
		L	R
.5A MAX

RGB

NOTE: A “C7” label is affixed to transmitters designed for STP201 or CAT 7 cable.

5

MTP RL 15HD A Receiver

1 2 3 4

Figure 6. Receiver Rear Panel

APower connector — Plug the included external 12 VDC power supply into this

2-pole captive screw connector (see Power Supply Wiring on page 12 to wire the connector).

BInput connector — Connect one end of the twisted pair cable from the transmitter or from the buffered output connector of an RL receiver to this RJ-45 female connector.

CBuffered output connector — Connect one end of a twisted pair cable to this female RJ-45 connector. Connect the free end of the same twisted pair cable from the receiver to the Input RJ-45 female connector on another receiver (see Twisted Pair Cable Termination on page 14 to wire the RJ-45 connectors).

DOutput video connector — Connect a projector or other high resolution video device to this 15-pin HD connector.

EMono audio output connector — Insert a 3.5 mm, 5-pole captive screw audio connector into this connector for two mono audio outputs. Wire the connector as shown in figure 7. Use the supplied tie-wrap to strap the audio cable to the extended tail of the connector.

No Ground Here

	Tip
	Ring
	Sleeves
Do not tin the wires!	Tip
	Ring

L	Tip	L
	Sleeves
R	Tip	R
	No Ground Here

Balanced Audio Output Unbalanced Audio Output

ATTENTION: Potential damage to property.

For unbalanced audio, connect the sleeve(s) to the ground contact.

DO NOT connect the sleeve(s) to the negative (-) contacts.

Figure 7. Captive Screw Audio Connector Wiring

NOTE: The length of the exposed wires in the stripping process is critical. The ideal length is 3/16 inches (5 mm). If the exposed section is longer, the exposed wires may touch, causing a short circuit between them. If it is shorter, the wires can be easily pulled out, even if tightly fastened by the captive screws.

MTP 15HD A Series • Installation and Operation 11