Headphone Output
Plugging in Headphone:
Insert a 3.5mm headphone jack into the Headphone Output socket. Use the Volume knob on the headphone to adjust the audio level.
Note: To make it so the sound only can be heard through the headphones press the A, B, C but- tons once to deselected speaker sets A, B and C. The LED indicators for each speaker set will be off.
Reset Button
The LCD display may fail to function normally due to the vehicle’s battery condition, and could require resetting the radio microprocessor if:
• The vehicle has been “jump started” from a dead battery condition.
• The vehicle battery becomes very low and is
• The vehicle battery is removed and replaced.
Should any of these conditions occur, simply press and release the RESET button on the radio front
panel using the tip of a ball point pen. This will reset Reset Button the radio microprocessor to the original factory set-
tings. After pressing the RESET button you should recheck to see if the radio functions normally.
Additional Feature
Area Radio Frequency Adjustment:
Note: If operating the unit in the USA, do not change the area.
To Change the Area:
1. Press the AM/FM button and “RADIO” appears in the display.
2. Press and hold the VOL/TONE knob until “SETUP” appears in the display.
3.Press the �ll button and “US” or “OCEAN” will be displayed.
4.Press the l�� or ��l button to change the setting to US or OCEAN.
5.Press the �ll button to save the setting. The unit will clear all the station settings. After wait- ing a few seconds the unit exit programming.
25