Kenmore 790.42003 manual Control Button Features, Setting the Clock

Control Button Features

READ THE iNSTRUCTiONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar with the various features and functions of the oven as described below. Detailed instructions for each feature

and function follow later in this Use & Care Guide.

SELECTOR CONTROL KNOB= Used to select the Bread Proof, Warm & Hold, Bake, Convection Bake, Convection Roast, Broil or Clean Feature.

OVEN TEMPERATURE CONTROL KNOB-- Used to select the Bread Proof, Warm & Hold, or the required Bake, Convection Bake, Convection Roast, Broil or Clean Temperature.

BREAD PROOF--
Used to set the	WARM & HOLD --
Bread Proof	Used	to set the
feature.	Warm	& Hold
	feature.

OVEN TEMPERATURE INDICATORS -- These indicators show the current

set temperature in the _,

oven. /

dS/¢_

BROIL-- Used to select the broil function.

CLEAN-- Used to select the Self- Cleaning cycle.

Lower Oven

CONVECTION			to select the
ROAST--	Used					@ _		I'°_
to select	the		BAKE--Used
			bake function.			_	//	CLOCK SET
convection
roasting	mode.			OVEN INTERIOR		_	/	PAD--Used to set
				LIGHTto turn PADSoven interior--Use,		_/		the time of day.
CONVECTION		BAKE--		light ON and OFF.		TIMER PADS--Used to set
Used to	select	the
						or cancel the minute timer,
Convection Bake			feature.
						The minute timer does not
				CONVECTION	CONVERT
						start		or stop cooking.
				Used to select	the

Convection Convert feature.

SCROLL PADS-- Used to scroll up or down for many functions.

PROBE	CONVECTION	CONVERT
PAD-- Used	Used to select	the
to set the	Convection Convert feature.
Probe
feature.

Setting the Clock

Clock

The ,:_ button is used to set the clock. Until the clock is set, all the other oven functions will not be available. The clock may be set for 12 or24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the appliance has been interrupted, the display will flash with "PF".

Clock

When PF flashes in the display, press the [_i!} button. No other button will stop the time from flashing.
To	set the	clock
		Clock
1.	Press the	button. The control		will beep once and	the time	of day will appear in the display.
2.	Tosettheclocktothecurrenttimeofday,			pressthe	orv[_r	buttontoincreaseordecreasethetimeofdayinl	minute
	increments,	or keep the i}	or _	button pressed	to increase or decrease the time of day in 10 minute		increments.

3.Release the button when the desired time is reached. Wait 5 seconds and the change will be accepted.

Changing between 12 or 24 hour time of day display

Clo_k

t.	Pressand	holdthe	_'!ibuttonfor6seconds. Thedisplaywill	showeither"12"(fort2	hourclock)or"24"(for24hourclock).
2.	Press the	or	button to switch between the t 2 and	24 hour time of day display.

3.Wait 6 seconds to accept the change.