Kramer Electronics user manual Connecting the TP-305A UXGA-Audio-RS-232 Line Receiver/DA

Connecting the TP-305A UXGA-Audio-RS-232 Line Receiver/DA

4.1The TP-305A UXGA - Audio - RS-232 Line Receiver/DA Underside

Figure 2 and Table 2 define the underside of the TP-305A

Feature

VS Switch1

HS Switch1

Figure 2: TP-305A Underside

Table 2: Features of the TP-305A Underside

Function

Slide the switch down, to set the V SYNC to its input polarity (NORMAL) Slide the switch up, to set the VS to negative polarity (INVERT)

Slide the switch down, to set the HS to its input polarity (NORMAL) Slide the switch up, to set the HS to negative polarity (INVERT)

5Connecting the TP-305A UXGA-Audio-RS-232 Line Receiver/DA

You can use the TP-305Awith a UXGA - Audio - RS-232 Line Receiver/DA such as the Kramer TP-1232. You can connect a single TP-305Ato up to five receivers, and up to five TP-305Aunits can be connected to increase the number of outputs to 25.

5.1Connecting a Single TP-305A

To connect a TP-123/TP-305AUXGA – Audio - RS-232/Line Receiver/DA system3 as illustrated in the example in Figure 3, do the following4:

1.On the TP-305A, connect the:

ƒUXGA OUT 15-pin HD computer graphics video connector to the UXGA acceptor (for example, a plasma display), and the AUDIO OUT ANALOG 3.5mm mini jack connector to the analog audio connector on the acceptor. If required, connect the RS-232 G and TX terminal block connector to the RS-232 port on the acceptor

ƒLINE OUTPUT RJ-45 connector on the TP-123to the LINE IN

1 By default, both switches are set to NORM.

2 Refer to the separate user manual, which can be downloaded at: http://www.kramerelectronics.com 3 Using up to 300ft (100m) of UTP cabling

4 Switch OFF the power on each device before connecting it to your TP-305A. After connecting your TP-305A, switch on its power and then switch on the power on each device

6 KRAMER: SIMPLE CREATIVE TECHNOLOGY