Pioneer P6800MP Installation, DIN Front/Rear-mount, DIN Front-mount, Removing the unit Fig

Connecting the Units <ENGLISH>

Installation <ENGLISH>

7When using a Subwoofer without using the optional amplifier

Antenna jack	Subwoofer output
15 cm (5-7/8 in.)

Note:

• Before making a final installation of the unit, tem-

porarily connect the wiring to confirm that the con-

nections are correct and the system works

properly.

•If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 4)

Removing the unit (Fig. 6) (Fig. 7)

Front output

16 cm (6-1/4 in.)

• Use only the parts included with the unit to ensure

proper installation. The use of unauthorized parts

Frame

To remove the frame, extend top and

This product

Subwoofer output

IP-BUS input (Blue)

Fuse

(10 A)

Jack for the Wired Remote Control
Please see the Instruction Manual for the		Multi-CD player
Wired Remote Control (sold separately).	IP-BUS cable	(sold separately)

can cause malfunctions.

• Consult with your nearest dealer if installation

requires the drilling of holes or other modifications

of the vehicle.

• Install the unit where it does not get in the driver’s

way and cannot injure the passenger if there is a

sudden stop, like an emergency stop.

• The semiconductor laser will be damaged if it

overheats, so don’t install the unit anywhere hot

— for instance, near a heater outlet.

60°

Fig. 4

bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)

•It becomes easy to remove the frame if the front panel is released.

Fig. 6

Blue/white

To system control terminal of the power amp or

Auto-antenna relay control terminal (max. 300

mA 12 V DC).

Yellow/black

If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections.

Yellow

DIN Front/Rear-mount

This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.

To terminal always supplied with power regardless of ignition switch position.

Red	White	Gray
To electric terminal controlled by ignition switch (12			+
	+
V DC) ON/OFF.	Front speaker
	≠	Gray/black	≠
Orange/white	White/black
	Left
To lighting switch terminal.
	Green	Violet

Front speaker

Right

Installation with the rubber bush (Fig. 5)

Dashboard

182

Holder

After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)

Fig. 7

Black (ground)	+		+
	Subwoofer
To vehicle (metal) body.	≠		≠
		Violet/black
	Green/black

Note:

Change the initial setting of this unit (refer to the Operation

Manual). The subwoofer output of this unit is monaural.

Subwoofer

Fig. 3

53

Rubber bush

Screw

Fig. 5