Connecting up | 02 |
Using the SR+ mode with a Pioneer plasma display
When connected using an SR+ cable, a number of features (such as automatic video input switching and volume muting on the plasma display) become available to make using this unit with your Pioneer plasma display even easier.
See also SR+ control options for Pioneer plasma displays on page 59 for information on setting up the unit.
1Make sure that the plasma display and this unit are switched on and that they are connected with an SR+ cable.
See Using this unit with a Pioneer plasma display above for more on connecting these components.
2To switch SR+ mode on/off, press SR+ (SHIFT + 7).
The front panel display shows the new setting; SR+ ON or SR+ OFF.
•If SR+ Error shows in the display, it means there is a communication problem between the unit and the plasma display. Check all connections and retry.
•The
•You won’t be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL OUT jack of your plasma display. You can use the remote sensor of the plasma display (even in standby) as long as the power isn’t switched off.
•The automatic volume muting feature is enabled separately; see SR+ control options for Pioneer plasma displays on page 59. (You can also use the System Setup menu to switch the SR+ mode of this unit.)
•If you disconnect the SR+ cable or switch the plasma display off while SR+ is on, the setting automatically reverts to SR+ OFF.
This displays an error if you switch the input of the unit with the plasma display switched off. Likewise, if this unit is switched off, the link with the plasma display will be terminated.
17
En