Pioneer S-HTD340 DVD/CD/Video CD player, Sound Demo shows, STANDBY/ON button

Page 74

12Additional information

Problem

Remedy

Sound Demo shows in

• Press and hold (stop) on the front panel for about five seconds. The

the display and the unit

disc tray ejects automatically to indicate the Sound Demo mode is

can’t be controlled.

disabled.

 

 

Timer indicator is blinking

• Unplug the system, then plug back in. Wait for one minute then switch

and the system will not

on.

switch on.

• Make sure the fan at the rear of the system unit is not being blocked.

 

• Check that the speakers are connected correctly.

 

• Make sure the voltage of the mains power source is correct for the

 

model.

 

• If the problem persists, take it to your nearest Pioneer

 

authorized service center or your dealer for servicing.

 

 

DVD/CD/Video CD player

Problem

Remedy

The disc is ejected

• Clean the disc.

automatically after

• Align the disc properly in the disc guide.

loading.

• If the region number on a DVD-video disc does not match the number

 

on the system unit, the disc cannot be used (see DVD Video regions on

 

page 68).

 

• Allow time for any condensation inside the system unit to evaporate.

 

Avoid using the system near an air-conditioning unit.

 

 

Playback is not possible.

• If the disc is loaded upside down, reload the disc with the label side face

 

up.

 

 

Picture playback stops

• Press (stop), then (play) to start playback again.

and the operation buttons

• Switch the power off once, then on again using the front panel

cannot be used.

STANDBY/ON button.

 

 

Settings are canceled.

• When the power is cut due to power failure or by unplugging the power

 

cord, settings will be canceled.

 

 

No picture/No color.

• Check that connections are correct and that plugs are inserted fully.

 

• Check the instruction manual of the TV/monitor to make sure the TV/

 

monitor settings are incorrect.

 

 

Screen is stretched or

• The TV Screen setting is incorrect. Set the TV Screen option to match

aspect does not change.

the TV/monitor you're using (see Video Output settings on page 63).

 

 

CD won’t play.

• Set the PhotoViewer menu option in the Initial Settings menu to Off to

 

be able to play some copy-protected CDs. See Options on page 65.

 

 

74

En

Image 74
Contents Protect your new investment Receive a free Pioneer newsletterWash hands after handling Important Safety Instructions Energy-saving design Contents Video Adjust menu Using the timerSurround sound and other settings Initial Settings menuBefore you start FeaturesPutting the batteries in the remote control Before you start ChapterBefore you start Disc / content format playback compatibilityUsing the remote control CD-R/RW compatibilityAbout WMA PC-created disc compatibilityCompressed audio compatibility Jpeg file compatibilityConnecting the speakers Connecting upConnecting up Chapter Match the colored wire with the color-coded Connecting upOn each wire Placing the speakersFront left Before mounting Connecting to your TVWall-mounting the surround speaker system Connecting using the S-video output Connecting using the component video outputPlasma display Projection monitor receiverUsing this unit with a Pioneer plasma display Listening to TV audio through this systemUsing the SR+ mode with a Pioneer plasma display To switch SR+ mode on/off, press SR+ Shift +Assembling the loop antenna Connecting up Connecting the supplied antennasPull off the protective shields of both AM antenna wires AM loop antennaConnecting the power FM wire antennaFront panel Controls and displaysControls and displays Chapter Controls and displays RPT and RPT-1 Timer indicatorsSpeaker indicators 12 2 PRO Logic IIControls and displays Remote control ST + Cursor buttons, Enter and tuning buttonsTune + QUIET/MIDNIGHTSR+ Shift + 7 Timer Shift + 6CH Level Shift + 5 Display Shift + 8Getting started Chapter Switching on and setting upGetting started Getting started Using the Room SetupSetting the clock Setting up the remote to control your TV To select a room type then press EnterGetting started Using the on-screen displays Playing discsBasic playback controls Press OPEN/CLOSE to open the disc tray Load a discResume and Last Memory Using the front panel controlsResume and Last Memory Last Memory belowPress Exchange or OPEN/CLOSE to close the disc tray Changing discsPress Exchange to open the disc tray Why won’t the disc I loaded play? DVD-Video disc menusVideo CD PBC menus Listening to the radioMemorizing stations Press Enter to save the station presetImproving poor FM reception Tune to a frequencySelect the source you want to listen to Listening to station presetsListening to other sources If necessary, start playback of the external sourceListening to your system Auto listening modePress Surround to select the ‘Auto’ listening mode Listening to your system ChapterListening to your system Listening in surround sound Dolby Pro Logic II Music settingsUse the cursor up/down buttons to adjust the setting Use the cursor up/down buttonsUsing Front Surround Press repeatedly to select fromListening to your system Listening with headphonesAdjusting the Advanced and Front Surround effect level Listening in stereoListening with a virtual surround back speaker Using Quiet and Midnight listening modesListening to your system Enhancing dialogue To adjust the sound Listening to your system Adjusting the bass and treblePress Sound Mode Boosting the bass levelPlaying discs Chapter Playing only CDs and WMA/ MP3 discs CD modePlaying discs Scanning discsUsing the Disc Navigator to browse the contents of a disc Frame advance/frame reverseTo resume normal playback, select ‘Off’ from the menu Using repeat playLooping a section of a disc Select a random play option Using random playSelect a repeat play option Select ‘Program’ from the list of functions on the left Creating and editing a DVD program listPress Home Menu and select ‘Play Mode’ Select ‘Create/Edit’ from the list of program optionsAdd further items to the program list in the same way Creating and editing a non- DVD program listPress Enter to add the highlighted item to the program list To play the program list, press playProgram Program Step Disc Folder Track Other functions available from the program menu Select a search modeSearching a disc Press Enter to start playbackSwitching camera angles Playing discs Switching subtitlesSwitching DVD audio language Zooming the screenFront panel display information Displaying disc informationOSD disc information Viewing Jpeg discs Chapter Using the Jpeg Disc Navigator and Photo BrowserViewing Jpeg discs Playing a Jpeg slideshowUse the cursor buttons Navigate Using the Photo BrowserViewing Jpeg discs Setting the wake-up timer Using the timerUsing the timer Chapter Set the switch-off timeTurning the wake-up timer on/off Using the timerSetting the sleep timer To check how much time is left, repeat steps 1 To select a switch-off time then pressTo select ‘Sleep?’ then press Enter Surround and sound setup options Surround sound and other settings ChapterUsing the System Setup menu Surround sound and other settings SR+ control options for Pioneer plasma displaysFunction setting for L1 input Function setting for DVD inputFunction setting for TV input Function setting for L2 inputWhen you’re done, press Enter to exit test tone setup Video Adjust Video Adjust menuVideo Adjust menu Chapter Creating your own presetsUsing the Initial Settings menu Initial Settings menuInitial Settings menu Chapter Video Output settingsDisplay settings Initial Settings menuLanguage settings Parental Lock Registering a new passwordOptions Setting/changing the Country code Changing your passwordSetting/changing the Parental Lock Select ‘Password Change’Additional information Optional system settingsSystem Setup menu options in standby Additional information ChapterAdditional information Resetting the systemUsing and taking care of discs Titles, chapters and tracksDiscs to avoid Handling discsStoring discs Proper installation and maintenance of this system External AM antenna Connecting external antennasConnecting auxiliary components External FM antennaButtons to select ‘Rec Mode?’ Recording modePress Sound Mode Use the Use To select ‘R.Mode On’ or ‘R.Mode Off’General Additional information TroubleshootingSee Using the remote control on STANDBY/ON button DVD/CD/Video CD playerSound Demo shows WMA/MP3/JPEG discs TunerError Messages Widescreen TV users Selecting languages using the language code listAdditional information Screen sizes and disc formats Standard TV usersAdditional information Language code list Country code listAdditional information Preset code list MarantzAdditional information Glossary Dolby DigitalAdditional information Specifications Accessories Speaker system SubwooferPage Pioneer Corporation