Pioneer AVH-P6450CD installation manual Connecting method

Page 6

Connecting the Units

Connecting the power cord (2)

When using this product with a back-up camera, automatic switching to VIDEO video when the gear shift is moved to the REVERSE (R) position is possible.

Connect the back-up camera to the VIDEO input.

This product

Power cable

Note:

• When you have completed lead wire connection, perform [VIDEO SETTING] correctly while referring to the Operation Manual.

• It is necessary to set to [BACK UP CAMERA] in the [VIDEO SETTING] when connecting the back-up camera.

Fuse resistor

Violet / white

Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE

(R)position. This connection enables the unit to sense whether the car is moving forwards or backwards.

Light green

Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch.

Parking brake switch

Power supply side

Ground side

Note:

The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer.

Connecting method

Clamp the parking

Clamp firmly with

brake switch power

needle-nosed

supply side lead.

pliers.

5

Fig. 3

Image 6
Contents Installation Manual English Español Português BConnecting the Units ContentsEnglish Español Deutsch Français Italiano Nederlands Connecting the power cord Refer to Fuse resistor Violet/white Yellow/blackEnglish Español Deutsch Français Italiano NederlandsConnecting method Français Connecting the system aEnglish Español Italiano NederlandsConnecting the system B Español Video Input / Output ConnectionEnglish Deutsch FrançaisDIN Front/Rear-mount DIN Front-mountDeutsch Français Italiano Nederlands HolderWhen the installation space is not very deep DIN Rear-mountScrew Dashboard or Console Factory radio mounting bracket Pioneer Corporation