Installation
7When the installation space is not very deep
When installing in a shallow space, secure with side brackets (small). In this case, stick conceal tape on parts that protrude from the dashboard.
Dashboard
182
53
Holder
After inserting the holder into the dash- board, then select the appropriate tabs according to the thickness of the dash- board material and bend them.
(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Conceal tape
Attach screw
Side bracket (small)
Fig. 11
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 12)
Frame
Pull out to remove the frame.
(When reattaching the frame, point the side with a groove downwards and attach it.)
Fig. 12
11